Foxconn G31MX Multi language Manual. - Page 24

Chapter 1 Main Features Jumpers This section explains how to setup jumpers. You should read the following content carefully prior to modifying any jumper settings. Attention The jumpers on the motherboard, pin 1 can be identified by the bold silkscreen next to it. And in this manual, pin 1 is simply labeled as "1". Clear CMOS Jumper: CLR_CMOS The CLR_CMOS jumper allows you to clear the data in CMOS. The data includes system setup information such as system password, data, time, and system setup parameters. To clear and reset the system parameters to default setup, please do as follows: 1. Turn off the computer and unplug the power cord from the power supply. 2. Move the jumper cap from pins 2-3 (default) to pins 1-2. Keep the cap on pins 1-2 for several seconds, then move the cap back to pins 2-3. 3. Plug the power cord and turn on the computer. 1 Normal (default) 1 Clear CLR_ CMOS USB device wake-up Jumper: USBPW1357_1/USBPW0246_1 1.Set the jumper to pins 1-2 (+5V) to wake up the computer from S1 sleep mode using the connected USB devices. 2.Set the jumper to pins 2-3 (+5VSB) to wake up the computer from S3 sleep mode using the connected USB devices. At the same time, a corresponding setting must be set in BIOS as below: Set "CMOS Setup"->"Power Management Setup"->"Power Management Events">"USB KB Wake-Up From S3" to "Enabled". 1 +5VSB 1 +5V (Default) USBPW 1357_1/USBPW 0246_1 18