Foxconn T70S User manual - Page 16

Front Panel Header : FP1 This motherboard includes one header for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. Serial ATA Connectors : SATA_1/2 The Serial ATA connector is used to connect with SATA Hard Disk or CD devices which support this feature. The SATA_2 allows up to 3GB/s data transfer rate, the SATA_1 support SATA 3.0 specification, and allows up to 6GB/s data transfer rate. TPM Header : TPM The TPM (Trusted Platform Module) provides the ability to the PC to run applications more secure and to make transactions and communication more trustworthy. To utilize this function, you should purchase additional device and install it. HARDWARE INSTALLATION 12 + + HDD-LED - PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 1 GND TX+ TXGND RXRX+ GND SATA_1 1 GND TX+ TXGND RXRX+ GND SATA_2 LCLK LFRAMEn LRESETn LAD3 VDD LAD0 NC_1 3D3V_DUAL GND LPCPDn 12 19 20 TPM GND EMPTY 5V_SYS LAD2 LAD1 GND NC_4 SERIRQ CLKRUNin NC_5 9