Frigidaire AEQ6700FS Operating Instructions - Page 1

DRYER OPERATING INSTRUCTIONS Before Operating Your Dryer • Adjustments to the cycle will be remembered each time that cycle is selected in the future. Read your dryer Owner's Guide. It has important • To return to factory settings, press Start/Pause safety and warranty information. It also has many and Select at the same time and hold until the suggestions for best drying results. signal sounds. To reduce the risk of fire, electric shock 5. Press Start/Pause to begin the cycle. or injury to persons, read the IMPORTANT SAFETY • To pause the cycle press Start/Pause. To INSTRUCTIONS in your dryer Owner's Guide before resume the cycle, press Start/Pause again. operating this appliance. • To stop or change the cycle, press Cancel. 6. A signal will sound at the end of the cycle and Operating Steps periodically during Extended Tumble when the Signal option is selected. When the cycle Read "Drying Procedures" in your Owner's Guide. It ends, remove items immediately and hang or fold. explains these operating steps in detail. 7. Clean the lint screen after every load. 1. Prepare items for drying. 2. Check that lint filter is clean and in place. 3. Load the dryer. If desired, add a dryer fabric softener sheet. Close the door. 4. Select the appropriate cycle and settings for each load. • Turn the Cycle Selector knob to select the cycle. The estimated drying time will be displayed. • A suitable drying temperature, dryness level and options will automatically be indicated for each cycle. See the "Dryer Setting Chart" for more details. • To change the temperature and dryness level, Cycle Selection Turn the Cycle Selector knob to the desired cycle. For best results, follow the fabric care label instructions on items to be dried. If the selection is changed after the cycle starts, the indicator lights will blink, the signal will beep and "ERR" will be displayed. To change the selection after the cycle has begun, press Cancel before making another choice. Just turning the knob to another selection will not change the cycle. The signal will beep and the status lights will flash, but the original cycle will continue. press Temperature or Dryness until the desired selections are made. • To select or delete an option, press Options; then, while the indicator is blinking, press Select. The indicator will light when the option has been selected. it will no longer be lighted Auto Dry Auto Dry cycles take the guesswork out of drying time. Loads dried using the Towels, Heavy Duty, Normal, Perm Press, and Delicates cycles will dry automatically at the selected temperature to the desired dryness level. when the option has been deleted. • If a temperature, dryness level or option is not available for a cycle, it will not light. The dryer uses sensing bars to sense the moisture level of the load as it tumbles through heated air. Auto Dry cycles save time and energy and protect fabrics. The estimated drying time will be displayed for about 5 minutes. Then the display will change to "Ad" to indicate drying time is automatically being determined by the sensors. When the load has reached the selected dryness level, it will continue to tumble, unheated, during a Cool Down period. This helps reduce wrinkling and makes items easier to handle during unloading. The estimated Cool Down time will be displayed. Drying time varies depending on size and dampness of load and fabric type. If the load is too small or almost dry, the sensing bars may not detect enough moisture to continue the cycle and the cycle may end after a few minutes. Select a Timed Dry setting to dry such loads. Room temperature and humidity, type of installation and electrical voltage or gas pressure can also affect drying time. Towels Select this Auto Dry cycle for towel loads. Heavy Duty Select this Auto Dry cycle for sturdy work clothes. Normal Select this Auto Dry cycle for cotton items. Perm Press Select this Auto Dry cycle for cottons and blends with a no-iron finish. Delicates Select this Auto Dry cycle for knits and delicate items. PN 134609300 (0511)