Frigidaire CPA12EDU1 Complete Owner's Guide - Page 7

Installation Instructions Installation Instructions (continued) Installation in a double-hung sash window 1. Cut the foam seals(adhesive type) to the proper lengths and attach them to the window and stool. (Fig. 10) 2. Open the window sash and place the window slider kit on the window stool (Fig. 11). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the width of window. Screw down the two screws on the window slider kit. See Fig.11. Cut the adjustable window slider kit if the width of window is less than 67.5cm (Fig. 12). 3. Close the window sash securely against the window slider kit. (Fig. 13) 4. Drive two 12.7 mm screws to secure the window slider kit to the window sash. (FIG. 13) 5. Secure the window slider kit to the window stool (FIG. 13): A: For wooden windows: Use 19mm screws for securing. B: For Vinyl-Clad windows: Use 12.7mm hex head cap screws for securing. 6. To secure lower sash in place, attach right angle sash lock with PPƎ VFUHZDVVKRZQ NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. 7. Cut the foam seal to an appropriate length and seal the open gap between the top window sash and outer window sash, as shown in Fig.15. screws Foam seal A (adhesive type) Fig. 10 Window slider kit 67.5cm~123cm Window stool Fig. 11 Cut this side to fit your window 12.7mm screws Window slider kit Foam seal Fig. 14 Fig. 15 19mm screws or 12.7mm hex head cap screws Window stool Fig. 13 Installation in a sliding sash window 1. Cut the foam seals(adhesive type) to the proper lengths and attach them to the window frame. See Fig.16. 2. Open the window sash and place the window slider kit on the window stool. See Fig.17. Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the height of window. Screw down the two screws on the window slider kit. See Fig.17.ḤCut the adjustable window slider kit if the height of window is less than 67.5cm (Fig. 12). 3. Close the sliding sash securely against the window slider kit. (Fig. 18) 4. Drive two 12.7mm screws to secure the window slider kit to the window sash. (Fig. 18) 5. Drive two 19mm screws to secure the window slider kit to the window stool. (Fig. 18) 6. Cut the foam seal to an appropriate length and seal the open gap between the sliding sash and outer window sash, as shown in Fig.19. 7. To secure the sliding sash in place, attach right angle sash lock with 12.7mm (1/2") screw as shown.(Fig.20) Foam seal (adhesive type) Window stool 67.5cm~123cm Window stool Fig. 12 Fig. 16 Window slider kit screws Fig. 17 Window slider kit Foam seal Fig. 19 2009 Electrolux Home Products, Inc. Fig. 20 19mm screws 12.7mm screws All rights reserved. Fig. 18 7