Frigidaire FAD301NWD Use and Care Guide - Page 5

Removing Collected Water, Operating Instructions - parts

Page 5 highlights

Operating Instructions Operating Instructions (continued) 1. To shut the unit down, rotate the humidity knob to the OFF position. NOTE: While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light. Removing Collected Water 1. Emptying the Bucket: a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate. b. Do not move the unit at this time otherwise water may spill on the floor. c. Press sides of bucket gently to unclip the bucket from the unit. d. Remove the bucket as shown in the photographs below and empty the bucket. WARNING Discard water from bucket. Water is not potable and cannot be used for drinking. e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again. f. You should hear a click when the bucket is in the correct position If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram. NOTE: Foam The foam embedded under the float(shown in the sideward diagram) is a functional part, which can not be removed. 2009 Electrolux Home Products, Inc. All rights reserved. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

5
2009 Electrolux Home Products, Inc.
All rights reserved.
1. To shut the unit down, rotate the humidity knob to the OFF position.
Removing Collected Water
1. Emptying the Bucket:
a.
When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
Operating Instructions
Operating Instructions
(continued)
While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light.
NOTE:
b.
Do not move the unit at this time otherwise water may spill on the floor.
c.
Press sides of bucket gently to unclip the bucket from the unit.
d.
Remove the bucket as shown in the photographs below and empty the bucket.
e.
Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f.
You should hear a click when the bucket is in the correct position
Discard water from bucket. Water is not potable and cannot be used for drinking.
WARNING
If the bucket full light does not extinguish, check that the float is
correctly snapped in place as indicated by the diagram.
The foam embedded under the float(shown in the sideward
diagram) is a functional part, which can not be removed.
NOTE:
Foam