Frigidaire FAD954DWD Complete Owner's Guide - Page 5
continued
View all Frigidaire FAD954DWD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Operating Instructions Operating Instructions (continued) 4. You can press the MODE button to select different kinds of operating mode. After each pressing of this button, the operating mode will switch among SLEEPING SPACE (55% RH), LIVING SPACE (50% RH), BASEMENT (45% RH) and CONTINUOUS modes, and the corresponding mode indicators will illuminate. NOTE: When you press the MODE button, the unit will always display the actual room humidity instead of the humidity settings. CLEAN FILTER LOCK TIMER FILTER TIMER HIGH MEDIUM LOW 65 FAN _ SPEED + SLEEPING SPACE LIVING SPACE BASEMENT BUCKET FULL CONTINUOUS POWER MODE CONTI NUOUS 5. You can also use the FAN SPEED button to change the fan speed to HIGH, Medium or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. CLEAN FILTER LOCK TIMER FILTER TIMER HIGH MEDIUM LOW 65 FAN _ SPEED + SLEEPING SPACE LIVING SPACE BASEMENT BUCKET FULL CONTINUOUS POWER MODE CONTI NUOUS 6. The CLEAN FILTER light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned and replaced, simply press the FILTER button to extinguish the light. CLEAN FILTER LOCK TIMER FILTER TIMER HIGH MEDIUM LOW 65 FAN _ SPEED + SLEEPING SPACE LIVING SPACE BASEMENT BUCKET FULL CONTINUOUS POWER MODE CONTI NUOUS 7. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0.5 hour to 24 hours. If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). + - TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the or button to change the delay timer at 0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining (8,7.5,7, etc.) until the unit either starts or stops. For the Delay Start, the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated. 2009 Electrolux Home Products, Inc. All rights reserved. 5