Frigidaire FAFW4011LW Complete Owner's Guide (English) - Page 22

IMPORTANT, Inside Cleaning Aggressive, WARNING - problems

Page 22 highlights

CARE AND CLEANING Inside Cleaning (Aggressive) In cases where System Clean Cycle along with care and cleaning of rubber gasket folds isn't done, and severe odor, mold, mildew, or residue buildup have developed, follow the below cleaning procedure to help alleviate the problem. CLEANING PROCEDURE - Washer Drum Ensure the wash tub is empty (or no clothes load). Open the detergent drawer and pour eight (8) cups of bleach into the detergent compartment on the left. Select System Clean cycle as described previously in Inside Routine Cleaning (Preventative). Upon cycle completion inspect the interior of the washer to see if the odor/residue has been eliminated. If any additional cleaning is required, repeat the above procedure. This may take several cycles depending on the severity of the odor/residue. You may observe some remaining discoloration due to the long term effects of this residue. For especially contaminated areas visible inside the drum (including the front rubber seal), these areas might be more effectively cleaned by spraying a Bleach Cleaner on a scrub brush, soft sponge, or towel and scrubbing. IMPORTANT Always wear rubber or latex gloves and protect floor and clothing from damage. If odor is still left after bleach cycle(s) and bleach cleaner, open the detergent drawer and pour one (1) pouch of TIDE® WASHING MACHINE CLEANER in detergent drawer. Select System Clean Cycle as above and start the washer. For best results Immediately follow up with a Spin Only Cycle. Select Fresh Water Rinse on Max Spin Speed with no detergent or bleach to help clear any residual bleach left after the System Clean Cycle. IMPORTANT See Inside Routine Cleaning (Preventative) for future cleaning maintenance which is necessary to avoid repeating issues. Í NOTE If the System Clean cycle is cancelled or paused during the cycle, the washer will go through 2 rinse cycles to clean the drum of any residual bleach before unlocking the door. sanitize hot warm cold cold water clean max high medium low no spin delay start chime stain clean energy saver freshwater rinse heavy normal light door lock sensing wash touch pause to add a garment auto temp spin speed select options soil level cancel START pause Press and hold both for ten seconds to enter System Clean cycle. WARNING HARMFUL VAPOR HAZARD Do not use or mix liquid chlorine bleach with other household chemicals such as toilet cleaners, rust removers, acid or products containing ammonia. These mixtures can produce dangerous fumes which can cause serious injury or death. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30

22
CARE AND CLEANING
Í
NOTE
If the
System Clean
cycle is cancelled or paused
during the cycle, the washer will go through 2 rinse
cycles to clean the drum of any residual bleach before
unlocking the door.
Immediately follow up with a Spin Only
Cycle. Select Fresh Water Rinse on Max
Spin Speed with no detergent or bleach
to help clear any residual bleach left
after the System Clean Cycle.
For best results
IMPORTANT
Always wear rubber or latex gloves and protect
oor
and clothing from damage.
IMPORTANT
See
Inside Routine Cleaning (Preventative)
for
future cleaning maintenance which is necessary to
avoid repeating issues.
Inside Cleaning (Aggressive)
WARNING
HARMFUL VAPOR HAZARD
Do not use or mix liquid chlorine bleach with other
household chemicals such as toilet cleaners, rust
removers, acid or products containing ammonia. These
mixtures can produce dangerous fumes which can
cause serious injury or death.
In cases where System Clean Cycle along with care and
cleaning of rubber gasket folds isn’t done, and severe
odor, mold, mildew, or residue buildup have developed,
follow the below cleaning procedure to help alleviate the
problem.
CLEANING PROCEDURE - Washer Drum
Ensure the wash tub is empty (or no clothes load). Open
the detergent drawer and pour eight (8) cups of bleach
into the detergent compartment on the left. Select
System Clean cycle as described previously in
Inside
Routine Cleaning (Preventative)
.
Upon cycle completion inspect the interior of the
washer to see if the odor/residue has been eliminated.
If any additional cleaning is required, repeat the above
procedure. This may take several cycles depending on
the severity of the odor/residue. You may observe some
remaining discoloration due to the long term effects of
this residue.
For especially contaminated areas visible inside the drum
(including the front rubber seal), these areas might be
more effectively cleaned by spraying a Bleach Cleaner on
a scrub brush, soft sponge, or towel and scrubbing.
If odor is still left after bleach cycle(s) and bleach cleaner,
open the detergent drawer and pour one (1) pouch
of TIDE
®
WASHING MACHINE CLEANER in detergent
drawer. Select System Clean Cycle as above and start the
washer.
heavy
normal
light
cancel
spin
speed
START
pause
soil
level
options
select
auto
temp
sanitize
warm
hot
cold
cold water
clean
max
medium
high
low
no spin
energy saver
stain clean
freshwater
rinse
chime
door lock
sensing
wash
touch pause
to add a garment
delay
start
Press and hold both for ten seconds
to enter
System Clean
cycle.