Frigidaire FAFW4011LW Product Specifications Sheet (English) - Page 3
Optional Accessories, Front Load Washer Specifications - installation guide
UPC - 012505382710
View all Frigidaire FAFW4011LW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Frigidaire Affinity (All L Models excluding FAFW4221L) Front Load Washers FAFW4011L B / W 3.47 D.O.E. Cu. Ft. / 4.0 I.E.C. Cu. Ft. Front Load Washer Specifications • Product Shipping Weight (approx.) - 222 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI/NFPA 70) and local codes & ordinances. (Do not use same circuit as dryer.) • Voltage Rating - 120V / 60 Hz / 15 Amps • Amps @ 120 Volts = 8 Amps • Equipped with 120V 3-wire power supply cord, approx. 60" long. • Always consult local and national electric & plumbing codes. • To maximize detergent effectiveness, ambient temperature should never be below 60° F. • Can be installed alone, with or without optional 15" Drawer Pedestal, or stacked below matching Frigidaire® Affinity Dryer, which requires installation of optional Dryer Stacking Kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.) • Can be built in with matching Frigidaire® Affinity Dryer in undercounter, recessed or closet installation. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.) • Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length 120 sq. in. opening also acceptable. Allow additional 1" clearance between fronts of units and closed door. • Do NOT install in area exposed to dripping water or outdoor weather conditions, or where gasoline or other flammables, including automobiles, are kept or stored. • Floor MUST be solid with 1" maximum slope. To minimize vibration or movement, reinforcement of floor may be necessary. Do NOT install on carpeted surface. • Leveling legs supplied to level washer properly and reduce excessive noise and vibration. • H/C water faucets MUST be installed within 42" of washer's water inlet and MUST be 3/4" to connect to 43" inlet hoses. • Water pressure MUST be between 30 and 120 psi with NOT more than 10 psi pressure difference between hot and cold. • Drain required with standpipe diameter of 1-1/4" min. and height of 24" min. / 96" max. above floor, capable of eliminating 17 gallons per minute. Attached 52" drain hose can reach 74"-high standpipe. For higher standpipe, optional Drain Hose Extension Kit available. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Dryer Stacking Kit - (PN # STACKIT4X). • 15" Classic Black Drawer Pedestal - (PN # CFPWD15B). • 15" Classic White Drawer Pedestal - (PN # CFPWD15W). • Mobile Home Installation Kit - (PN # 137067200). • Drain Hose Extension Kit - (PN # 137098000). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FAFW4011L 04/11 © 2011 Electrolux Home Products, Inc. Specifications subject to change. Printed in the U.S.A.