Frigidaire FAQE7072LR Wiring Diagram (All Languages) - Page 3
Snder the Tdisplay
UPC - 012505382406
View all Frigidaire FAQE7072LR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Selector Position 0 Test/Activated Component Electric Gas Lights / Buttons test 1 Motor Clockwise (CW) 2 Contact Sensor Diagnostic Mode Operator Check LCD row Check Motor function. Look for Drum rotation in clockwise direction "MOTOR CW" Check moisture reading. Place fingers across Contact Sensor and look for digit display to change from "1111" to "8888" "MOIST. BARS" 3 Motor Clockwise (CW) Check Motor function. Look for Drum rotation in clockwise direction "MOTOR CW" 4 Lights / Buttons test + Motor CW Lights / Buttons test + Motor CW + igniter Check all buttons and lights. Press all buttons and check for beep and button ID number in digit display. Check to see that all Lights function 5 Motor CW + Heater 1 Motor CW + Heater Check Motor and Heater function. Check Outlet Control Thermistor value in digit display. "HEAT1 - NTC1" 6 Motor CW + Heater 1 + Heater 2 Motor CW + Heater Check Motor and Heater function. "HEAT2 - NTC2" 7 Motor CW + Heater 1 + Heater 2 + Heater 3 Motor CW + Heater Check Motor and Heater function. Check Outlet Control Thermistor value in digit "HEAT3 - NTC1" display. 8 Motor CW Check for Mist "MIST VALVE" 9 Error code history display Check last 5 error codes displayed (See Table above for error code definitions) 10 Software version Software version Software version LCD digits "1111" if Contact Sensor open circuit;"8888" if Contact Sensor short circuited button id number Outlet Control Thermistor value (degrees F) Inlet Control Thermistor value (degrees F) Outlet Control Thermistor value (degrees F) error code Software version NOTE : To clear the error code (s): Press and hold the center key under the display and "cancel" buttons simultaneously for 3 seconds. 6. To exit Diagnostic Mode: a) Unplug the power cord, wait 5-8 seconds, then reconnect the power cord OR b) Turn the program knob to the Start Position (lights/Buttons Test). Press the "cancel" and center button under the display simultaneously for 6 seconds. 3