Frigidaire FAQG7011LB Wiring Diagram (All Languages) - Page 2
FUNCTION TEST SEQUENCE, SELECT, CANCEL, OPTIONS, Drying, Cool Down, More Dry, Temperature, Dryness, - dryer
UPC - 012505382536
View all Frigidaire FAQG7011LB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
FUNCTION TEST SEQUENCE 1. Turn knob to sixth position from the left. 2. Press and hold SELECT and CANCEL simultaneously for six seconds. The buzzer will sound one time. 3. Immediately press and hold OPTIONS and CANCEL simultaneously for two seconds. The control will enter test mode, the buzzer will sound three times and all LEDs will rapidly flash. After entering the test mode, the cycle selector knob can now be rotated to select the following tests: Rotate the cycle selector knob clockwise from the starting position: 0 turns: All LEDs will flash. 1 turn: Drive motor runs; heat source is on. Drying LED is lit. "H" and the control thermistor reading will toggle back and forth in the display. 2 turns: Drive motor runs; heat source is off. Cool Down LED is lit and "AF" (Air Fluff) is displayed. 3 turns: Drive motor runs; heat source is off. Drying and Cool Down LEDs are lit and numbers appear in the display showing moisture sensor readings. Opening the door (press in on door switch plunger) and placing a finger on the both moisture sense bars at the same time will make the numbers decrease. In controls that do not have a digit display, the More Dry LED should be ON. Opening the door (press in on door switch plunger) and placing a finger on the both moisture sense bars at the same time will make the Damp LED come on. 4 turns: Drive motor runs; heat source is off. Key test: a. When the Temperature key is pressed, all the temperature LEDs should light. b. When the Dryness key is pressed, all the dryness level LEDs should light. c. When the Options or Select key is pressed, all the Option LEDs should light. d. When the Start/Pause key is pressed, all the cycle status LEDs should light. e. When the Cancel key is pressed, all the cycle status LED's should light. 5 turns: Drive motor runs; heat source is off. Cool Down LED is lit. Control thermistor reading is displayed. 6 turns: Drive motor runs; heat source is on. Drying LED is lit. Control thermistor reading is displayed. 7-11 turns: All LEDs will flash To EXIT test mode, press and hold the Select and Cancel buttons simultaneously for 6 seconds or disconnect power from dryer. Dryer will be reset for regular operation.