Frigidaire FAQG7077KN Use and Care Manual - Page 5

Features, Care and Cleaning - water filter

Page 5 highlights

Features END OF CYCLE SIGNAL A signal will sound at the end of the cycle and periodically during Extended Tumble (some models) at the volume level selected. STATUS DISPLAY The estimated total cycle time will be displayed when the cycle is selected. The estimated remaining cycle time is displayed during the cycle. DRUM LIGHT (some models) The drum light will come on whenever the door is opened to illuminate the drum during loading and unloading. Closing the door turns off the light. REVERSIBLE DOOR Your dryer is equipped with a reversible door. The door can be hinged on the right or left side. For step-by-step instructions on DOOR REVERSAL, refer to the Installation Instructions supplied with this dryer. DRYING RACK (some models) Use the drying rack to dry items which should not be tumble dried. Insert the rack into the dryer drum, resting the back support on the moisture sensor bars and the front legs on the air grill. moisture sensing bars Place items to be dried on top of the rack, leaving space between items and not allowing them to hang over the sides or through the holes. The weight should not exceed 10 lbs (4.5 kg). Select the air (no heat) setting for items containing plastic, foam rubber, rubber-like materials, feathers or down. When items are dry, remove the rack and store it in a convenient location. Care and Cleaning - FIRE HAZARD - A clothes dryer produces combustible lint. The dryer must be connected to an outdoors exhaust. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the opening and in the surrounding area. every load. Clean the lint filter after To reduce risk of fire or serious injury to persons or property, comply with the basic warnings listed in the Important Safety Instructions and those listed below. • Before cleaning the dryer interior, unplug the electrical power cord to avoid electrical shock hazards. • Do not use any type spray cleanser when cleaning the dryer interior. Hazardous fumes or electrical shock could occur. INSIDE • Clean the lint filter after every load. Lint build-up on the filter restricts air flow, which causes longer drying times. The filter is located at the bottom of the door opening. Remove by pulling straight up. Remove the lint and replace the filter. • Occasionally a waxy build-up may form on the lint filter and/or moisture sensing bars from using dryer-added fabric softener sheets. To remove this build-up, wash them with warm, soapy water. Dry the filter thoroughly and replace. Do not operate the dryer without the lint filter in place. • If the dryer drum becomes stained from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser. Remove cleanser residue before drying the next load. • Every 18 months an authorized servicer should clean the dryer cabinet interior and exhaust duct. These areas can collect lint and dust over time. An excessive amount of lint build-up could result in inefficient drying and possible fire hazard. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9

5
Features
END OF CYCLE SIGNAL
A signal will sound at the end of the cycle and periodically
during Extended Tumble (some models) at the volume level
selected.
STATUS DISPLAY
The estimated total cycle time will be displayed when the
cycle is selected. The estimated remaining cycle time is dis-
played during the cycle.
DRUM LIGHT (some models)
The drum light will come on whenever the door is opened to
illuminate the drum during loading and unloading. Closing
the door turns off the light.
REVERSIBLE DOOR
Your dryer is equipped with a reversible door. The door can
be hinged on the right or left side.
For step-by-step instructions on DOOR REVERSAL,
refer to the
Installation Instructions
supplied with this dryer.
DRYING RACK (some models)
Use the drying rack to dry items which should not be tumble
dried. Insert the rack into the dryer drum, resting the back
support on the moisture sensor bars and the front legs on the
air grill.
Place items to be dried on top of the rack, leaving space
between items and not allowing them to hang over the sides
or through the holes. The weight should not exceed 10 lbs
(4.5 kg). Select the air (no heat) setting for items containing
plastic, foam rubber, rubber-like materials, feathers or down.
When items are dry, remove the rack and store it in a conve-
nient location.
Care and Cleaning
Before cleaning the dryer interior, unplug the electrical power cord to avoid
electrical shock hazards.
Do not use any type spray cleanser when cleaning the dryer interior. Haz-
ardous fumes or electrical shock could occur.
INSIDE
Clean the lint filter after every load. Lint build-up on the filter restricts air
flow, which causes longer drying times. The filter is located at the bottom
of the door opening. Remove by pulling straight up. Remove the lint and
replace the filter.
Occasionally a waxy build-up may form on the lint filter and/or moisture
sensing bars from using dryer-added fabric softener sheets. To remove this
build-up, wash them with warm, soapy water. Dry the filter thoroughly and
replace. Do not operate the dryer without the lint filter in place.
If the dryer drum becomes stained from noncolorfast fabrics, clean the
drum with a damp cloth and a mild liquid household cleanser. Remove
cleanser residue before drying the next load.
Every 18 months an authorized servicer should clean the dryer cabinet
interior and exhaust duct. These areas can collect lint and dust over time.
An excessive amount of lint build-up could result in inefficient drying and
possible fire hazard.
Clean the lint filter after
every load.
To reduce risk of fire or serious injury to persons or property,
comply with the basic warnings listed in the Important Safety Instructions and
those listed below.
- FIRE HAZARD -
A clothes
dryer produces combustible lint. The dryer
must be connected to an outdoors exhaust.
Regularly inspect the outdoor exhaust open-
ing and remove any accumulation of lint
around the opening and in the surrounding
area.
moisture sensing
bars