Frigidaire FARE4044MW Product Specifications Sheet (English) - Page 3
Optional Accessories, Top Load Dryer Specifications
View all Frigidaire FARE4044MW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
FARE4044M W Dryer 7.0 Cu. Ft. D.O.E. Electric Top Load Dryer Specifications • Product Shipping Weight (approx.) - 143 Lbs. • Designed for HOME USE only, not recommended for commercial application. • An electrical supply with grounded three-prong receptacle is required. • Voltage Rating - 240V / 60 Hz / 30 Amps • Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. (Do not use same circuit as washer.) • Connected Load (kW Rating) @ 240 Volts = 5.4 kW • Amps @ 240 Volts = 24 Amps • Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or 4-conductor NEMA 14-30 type SRDT or ST (as required), rated at 240 volt AC minimum, 30 amp power supply cord marked for use with clothes dryers (not supplied). • Grounding through neutral link prohibited in specific applications and certain locales, requiring use of 4-wire system. (For detailed electrical requirements, refer to Product Installation Guide on web.) • Always consult local and national electric codes. • Dryer can be installed in recess or closet requiring 0" minimum installation clearance around sides and back of unit. To achieve 0" minimum rear clearance, dryer MUST be vented straight back. Closet installation requires additional 1" minimum clearance between front of unit and vented door. Door MUST be vented with 120 sq. in. minimum louvered opening, equally divided, located 3" from top and bottom of door. A louvered door with equivalent air openings for full-length of door is acceptable. Air openings MUST remain unobstructed with door installed. (For additional installation details, refer to Product Installation Guide on web.) • Do NOT install in area exposed to dripping water or outdoor weather conditions; where gasoline or other flammables are kept or stored; or where dryer comes in contact with curtains, drapes or anything that will obstruct flow of combustion and ventilation air. • For garage installation, dryer MUST be located minimum 18" above floor. • Floor MUST be solid with 1" maximum slope. Do NOT install on carpeted surface. • Dryer MUST exhaust to outside of building, NOT into any concealed space. • Exhaust installation requires minimum 4"-diameter rigid or semi-rigid metal duct with approved, unobstructed vent hood having swing-out damper(s). If installing rigid metal duct (preferred), do not exceed MAXIMUM venting run length of 64 ft., allow deductions for elbows and vents. If installing semi-rigid metal duct, do not exceed MAXIMUM venting run length of 8 ft., always allow deductions for elbows and vents (Refer to Product Installation Guide on web for additional information). Do NOT use flexible plastic or metal foil duct and use shortest run possible. • Leveling legs supplied to level dryer properly and reduce excessive noise and vibration. • For manufactured or mobile home installation optional Mobile Home Installation Kit (PN # 137067200) required. (For specific installation details, refer to Product Installation Guide on web.) Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Mobile Home Installation Kit - (PN # 137067200). • Drying Rack - (PN # 137067300). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FARE4044M 06/12 © 2012 Electrolux Home Products, Inc. Specifications subject to change.