Frigidaire FCCG3627AS Installation Instructions - Page 8
Check Operation, Model and Serial Number Location
![]() |
View all Frigidaire FCCG3627AS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
GAS COOKTOP INSTALLATION INSTRUCTIONS (For 30" & 36" Models) Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. Disconnect electrical supply cord from wall receptacle before servicing cooktop. Preferred Method Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug. Figure 9 Model and Serial Number Location The serial plate is located on the underside of the cooktop (see Figure 10). When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate of your cooktop. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the cooktop was adjusted for when it left the factory. The cooktop is not removeable. Do not attempt to remove or lift the cooktop. To prevent flare-ups and avoid creation of harmful by-products, do not use the cooktop without all burner caps properly installed to insure proper ignition and gas flame size. Always keep the burner caps and burner heads in place whenever the surface burners are in use. Do not allow spills, food, cleaning agents or any other material to enter the gas orifice holder openings. Check and be sure the size of each burner cap matches the size of the burner head. Check and be sure that all round style burner caps are correctly in place on round burner heads. Check and be sure that all oval style burner caps are correctly in place on oval burner heads (if equipped). Check and be sure that all dual or twin style burner caps are correctly in place on dual or twin burner heads (if equipped). On round style burners, the burner cap should fit snug into the center of burner head and be level. Refer to Figure 11 for correct and incorrect burner cap placement. Once in place, you may check the fit by gently sliding the burner cap from side to side (Fig. 12) to be sure it is centered and firmly seated. Please note that the burner cap should NOT move off the center of the burner head when sliding from side to side. Burner Cap Serial plate is located under the burner box. Figure 10 Check Operation Refer to the Use and Care Guide packaged with the appliance for operating instructions and for care and cleaning of your cooktop. Do not touch the burners. They may be hot enough to cause burns. 1. Check Burner Cap Placement Regular burner It is very important to be sure that all surface burner caps and burner grates are properly installed and in the correct locations before operating the appliance. 8 Burner Head Orifice Holder Ignitor Figure 11
![](/manual_guide/products/frigidaire-gccg3648as-installation-instructions-5943d12/8.png)