Frigidaire FCWM3027AB Installation Instructions - Page 7

Checking Operation

Page 7 highlights

MICROWAVE/WALL OVEN COMBINATION INSTALLATION 7. Adjust Microwave Front Frame Screws Use a manual screwdriver to adjust the screws on the microwave front frame for a flush fit (see figure 8). ADJUST SCREWS AJUSTAR LOS TORNILLOS AJUSTER LES VIS microwave front frame screws 316106139 align micro- wave frame front to back Figure 8: Adjust Front Frame Screws 4. Leveling the Wall Oven 1. Install an oven rack in the center of the oven (see Figure 9). 2. Place a level on the rack. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level if necessary. 3. If the level indicates that the rack is not level, use wood shims. 5. Checking Operation Your model is equipped with an Electronic Oven Control. Each of the functions has been factory checked before shipping. However, it is suggested that you verify the operation of the electronic oven controls once more. Refer to the Use and Care Guide for operation. 1. Remove all items from the inside of the oven. 2. Turn on the power to the oven (Refer to your Use & Care Guide.) 3. Verify the operation of the electronic oven controls: Bake - Verify that this function makes the oven hot. 20 seconds after turning oven on, open the door and you should feel heat coming from the oven. Broil - When the oven is set to BROIL, the upper element in the oven should become red. IMPORTANT NOTE A cooling fan inside the upper rear part above the oven (some models) provides cooling of the oven electrical and electronic components. If the oven has been operating at high temperatures, the fan will continue to run after the oven is turned off. Before You Call for Service Read the Before You Call for Service Checklist and operating instructions in your Use and Care Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Refer to your Use and Care Guide for service phone numbers. Figure 9: Leveling 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

7
MICROWAVE/WALL OVEN COMBINATION INSTALLATION
5. Checking Operation
Your model is equipped with an Electronic Oven
Control. Each of the functions has been factory
checked before shipping. However, it is suggested
that you verify the operation of the electronic oven
controls once more. Refer to the Use and Care Guide
for operation.
±. Remove all items from the inside of the oven.
2. Turn on the power to the oven (Refer to your Use &
Care Guide.)
³. Verify the operation of the electronic oven controls:
Bake
- Verify that this function makes the oven hot.
20 seconds after turning oven on, open the door and
you should feel heat coming from the oven.
Broil - When the oven is set to BROIL, the upper
element in the oven should become red.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
4. Leveling the Wall Oven
±.
Install an oven rack in the center of the oven (see
Figure 9).
2.
Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then
the other. Use wood shims under the wall oven to
level if necessary.
³.
If the level indicates that the rack is not level, use
wood shims.
Figure 8: Adjust Front Frame Screws
IMPORTANT NOTE
A cooling fan inside the upper rear part above
the oven (some models) provides cooling of the
oven electrical and electronic components. If the
oven has been operating at high temperatures,
the fan will continue to run after the oven is
turned off.
·.
Adjust Microwave Front Frame Screws
Use a manual screwdriver to adjust the screws
on the microwave front frame for a flush fit (see
figure 8).
Figure 9: Leveling
316106139
ADJUST
SCREWS
AJUSTAR LOS
TORNILLOS
AJUSTER
LES VIS
micro-
wave
front
frame
screws
align
micro-
wave
frame
front to
back