Frigidaire FFBC46F5LS Complete Owner's Guide (English) - Page 6

Energy Saving Tips - use as a build in

Page 6 highlights

INSTALLATIONChart 2 Step 7:Remove the bolt on the bottom of the door by screwdriver�(see chart 3) Step 8:Remove the screw� and the block �,then set them on the left side.(see chart 3) Stop Ľ bracketľ Bushingļ Fig. 6 Chart 3 and fixSttehpe9to:Cphhainnggeethoen hthinegdeoaoxris,t�o mfroamkethteherigdhotohrolleevteol,lseeftehcohlea(rste8e.chart 4) Step 14:Check the sealing of the door,then refit the parts �ǃ�. Fig. 7 Ŀ Chart 4 Step 10:Use knife to remove the parts�,see chart 5. - 8 - Chart 8 Placement of Wine Cooler The wine cooler should be placed in dry and ventilated room. The location of the wine cooler should not be irradiated by direct sunshine. The wine cooler should be far away from heating sources, such as: cooking stove or heating radiator. If the wine cooler has to be placed near heating source, please adopt proper heating insulation board for insulation or keep the wine cooler at least the following minimum distances away from the heating sources: For electric stove: 3 ΁. For oil or coal stove: 30 ΁. Replacement of Door Hinge The door hinges of this wine cooler can be interchanged between the left and right sides. Installation of Handle 1. Set the handle on the fixation shaft. ENERGY SAVING TIPS • Install the beverage cooler in the coolest part of a dry and ventilated room, out of direct sunlight and away from heating ducts or registers. Do not place the beverage cooler next to heatproducing appliances such as a range, oven or dishwasher. • Level the beverage cooler so the door close tightly. • Do not over crowd the beverage cooler or block cold air vents. Doing so causes the beverage cooler to run longer and use more energy. Shelves should not be lined with aluminum foil, wax paper or paper toweling. Liners interfere with cold air circulation, making the beverage cooler less efficient. • Wipe containers dry before placing them in the beverage cooler. This cuts down on moisture build-up inside the unit. • Organize the beverage cooler to reduce door openings. Remove as many items as needed at one time and close the door as soon as possible. - 10 - 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11

6
Fig. 7
Chart 3
Fig. 6
Bushing
Stop
bracket
Install the beverage cooler in
the coolest part of a dry and
ventilated room, out of direct
sunlight and away from heating
ducts or registers. Do not place
the beverage cooler next to heat-
producing appliances such as a
range, oven or dishwasher.
Level the beverage cooler so the door close tightly.
Do not over crowd the beverage cooler or block
cold air vents. Doing so causes the beverage cooler
to run longer and use more energy. Shelves should
not be lined with aluminum foil, wax paper or paper
toweling. Liners interfere with cold air circulation,
making the beverage cooler less efficient.
Wipe containers dry before placing them in the
beverage cooler. This cuts down on moisture build-up
inside the unit.
Organize the beverage cooler to reduce door
openings. Remove as many items as needed at one
time and close the door as soon as possible.
ENERGY SAVING TIPS
INSTALLATION