Frigidaire FFBD1821MS Installation Instructions (English) - Page 10

Installation Instructions STEP 12 CONNECT DRAIN LINE FOLLOW ALL LOCAL CODES AND ORDINANCES. The drain hose molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation. Cutting Lines DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer using either previously determined method. Method 1 - Air gap with waste tee or disposer 1" 3/4" 5/8" Figure U IMPORTANT: Do not cut corrugated portion of hose • If a longer drain hose is required, add up to 42" of length for a total of 10 ft. to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps. Waste Tee Installation Disposer Installation Figure W Method 2 - High drain loop with waste tee or dis- poser Fasten to underside Fasten to underside of countertop of countertop 32" 18" Min. 18" Min. Min. Hose Clamp Coupler Hose Clamp Figure V • Secure the drain hose to the air gap, waste tee or disposer with clamps. NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION. Waste Tee Installation Disposer Installation Figure X IMPORTANT - When connecting drain line to disposer, check to be sure that drain Remove Disposer Plug plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer. 10