Frigidaire FFBD2411NB Product Specifications Sheet (English) - Page 3

24" Built-In Dishwasher w/Ready-Select Controls (RSC) Baseline Dishwashers FFBD2411N S / M / W/ B / Q 24" Built-In Dishwasher Specifications • Product Shipping Weight (approx.) - 64 Lbs. • Voltage Rating - 120V / 60 Hz / 15 Amps (maximum 20 Amps if connected with disposer) • Connected Load (kW Rating) @ 120 Volts = 1.44 kW (For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.) • Amps @ 120V = 10 Amps • Always consult local and national electric & plumbing codes. Meets requirements of ASSE 1006 - integral air gap on supply. • Water Pressure - Hot water line to dishwasher must provide between 20 and 120 pounds per square inch (psi). • Make sure location has right drain, water and electrical outlets to make connections. • Keep back free of drain, water & electrical supply. • Electrical and water supplies should enter cabinet opening on floor, or through back or side walls, as shown in shaded areas. • Connections preferably located toward left side of dishwasher. Do not cross drain, water or electrical lines in front of motor, blower or frame. • When installing adjacent to wall, cabinet or other obstruction that extends beyond front edge of unit, allow 2" minimum clearance between opened door and obstruction. • When installing at end of cabinet line, sides must be fully enclosed. • Do not install unit under a cooktop, damage will occur. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FFBD2411N 03/12 © 2012 Electrolux Home Products, Inc. Meets requirements of ASSE 1006 Specifications subject to change.