Frigidaire FFEF3005MW Complete Owner s Guide - Page 8

SETTING SURFACE CONTROLS Operating surface elements CAUTION • Surface elements may appear to have cooled after they have been turned off. The element surface may still be hot and burns may occur if the element or the area surrounding the element is touched before it has cooled sufficiently. • Do not place flammable items such as plastic salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements. • Protective liners-Do not use aluminum foil to line surface drip bowls, or reflector pans. Improper installation of these liners may result in risk of electric shock, or fire. Only use aluminum foil as recommended in this manual. To operate surface elements: 1. Place correctly sized cooking utensil on surface element. 2. Push in and turn the surface control knob (See Fig. 1). in either direction to the desired setting. Start most surface cooking on a higher setting and then turn to a lower setting to finish. The surface control knobs do not have to be set exactly on a particular spot. Use the graphics provided as a guide and adjust the control knob as needed (See Fig. 2). Each surface element provides a constant amount of heat at each setting. For more information see the Suggested surface element settings table (See Fig. 3). 3. When cooking is complete, turn the surface element OFF before removing the cookware. NOTES • The surface indicator light will glow when one or more surface elements are turned ON. A quick glance at this indicator light when finished surface cooking is an easy check to be sure all surface controls are turned OFF. • The size and type of utensil used, and the amount and type of food being cooked will influence the surface setting needed for best cooking results. Fig. 1 Fig. 2 Suggested surface element settings The suggested settings table provided below are based when cooking with medium-weight aluminum pans with lids. Settings may vary when using other types of pans. Suggested surface element settings table Settings Type of cooking High (Hi - 9) Start most foods, bring water to a boil, pan broiling Medium high (7 - 8) Continue a rapid boil, fry, deep fat fry Medium (5 - 6) Maintain a slow boil, thicken sauces and gravies or steam vegetables Medium Low (2 - 4) Keep foods cooking, poach, stew Low (LO or SIM - 1) Keep warm, melt, simmer Fig. 3 IMPORTANT Do not allow aluminum foil, or ANY material that can melt to make contact with the surface elements. 8