Home » Frigidaire Manuals » Ranges » Frigidaire FFEF3010UB » Manual Viewer

Frigidaire FFEF3010UB Complete Owners Guide - Page 24

Cleaning under bake element some models, Cleaning under cooktop some models

View all Frigidaire FFEF3010UB manuals

Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

CARE AND CLEANING Cleaning under bake element (some models) The bake element is located in the lower oven cavity. For some models, if the lower bake element is visible it may be tilted up for easier access to the oven bottom for cleaning. Remove the oven racks before raising the element. Be careful not to raise the element more than 4 or 5 inches from the resting position. Cleaning under cooktop (some models) CAUTION When lowering the lift-up range cooktop, grasp the sides with fingertips only. Be careful not to pinch fingers. Do not drop or bend the range cooktop when raising or lowering. This could damage the cooktop surface. cooktop support rods Figure 16: Lift bake element Figure 17: Lifting cooktop To raise the cooktop for cleaning (some models) 1. Grasp the sides and lift from the front (See Figure 17). Lift-up rods will support the top in a raised position. Only lift the cook top far enough to allow the support rods to snap into place. 2. Clean underneath using a clean cloth and hot, soapy water. To lower, hold the cooktop up and gently push back on each rod to release the notched support. Hold the cooktop while slowly sliding the lift rods down into the range frame. 24

Section	Page
Table of contents	1
Questions?	2
Product Registration	2
Record model & serial numbers here	2
Serial Plate Location	2
Need Help?	2
Visit the Frigidaire web site at www.frigidaire.com	2
Read this Use & Care Manual	2
If You Received a Damaged Range...	2
Save Time and Money	2
Product Record and Registration	2
Important Safety Instructions	3
Bakeware	9
Cooking Conditions	10
Cooking Results	10
Cooking Tips	10
Using Proper Cookware	12
Figure 1: Testing cookware	12
Figure 2: Proper cookware	12
Cookware Material Types	12
Surface and Oven Indicator Lights	13
Figure 3: Indicator lights	13
Radiant surface elements	14
1. Place correctly sized cookware on the radiant surface element.	14
2. Push in and turn the surface control knob in either direction (Figure 4) to the desired setting (refer to the “Suggested radiant surface element settings” table, Table 1).	14
3. When cooking is complete, turn the radiant surface element OFF before removing the cookware.	14
Suggested radiant surface element settings	14
Table 1: Suggested settings for radiant elements	14
Figure 4: Surface control knob (back)	14
Home Canning	15
Oven Vent Location	16
Figure 5: Oven vent	16
Types of oven racks	16
Figure 6: Oven rack types	16
Removing, replacing, and arranging flat or offset oven racks	16
Before Setting Oven Controls	16
1. Press clock key.	17
2. Press in and hold or key until the correct time appears in the display. The UP arrow key will increase time and DOWN arrow key will decrease time.	17
Operating oven light (some models)	17
Setting bake	18
Figure 7: Pan spacing suggestions	18
1. Arrange oven racks while the oven is still cool.	18
2. Turn the oven temp. control knob to the desired oven temperature (Figure 8).	18
3. Preheat the oven for 10 to 12 minutes before baking. Preheating is not necessary when roasting, cooking casseroles or broiling most foods.	18
4. When finished cooking, turn the oven temp. control knob to OFF position.	18
Figure 8: Oven temperature control	18
Figure 9: Rack positions	18
Setting broil	19
1. Arrange oven racks while the oven is still cool.	19
2. Turn the oven control knob to broil. Most foods can be broiled at the broil setting. Preheat the oven if desired.	19
3. Place the insert on the broiler pan (if equipped), then place the food on the insert. Do not use the broiler pan without the insert or cover the insert with aluminum foil (Figure 11). The exposed fat could ignite.	19
4. Place the broiler pan on the oven rack. Leave the oven door open at the broil stop position when broiling (Figure 12).	19
5. Broil on one side until food is browned; turn and broil on the second side. Season and serve.	19
6. When broiling is finished, turn the oven temp control knob to OFF	19
Figure 10: Be sure to set oven control to broil.	19
Figure 11: Broil rack positions and broil pan insert	19
Figure 12: Open door to stop position when broiling	19
Figure 13: Use cleaners with caution	20
Surface elements and drip bowls	22
Figure 14: Coil element	22
1. Lift the edge of the drip bowl across from the terminal end. Lift the surface element and drip bowl together just enough to clear the cooktop.	22
2. While holding the drip bowl and surface element, gently pull the terminal end out from terminal plug. Do not remove the hold-down clip (if equipped) from the drip bowl..	22
Figure 15: Removing coil and drip bowl	22
Cleaning drip bowls	23
1. Slide the terminal end on the element through the opening in the drip bowl.	23
2. Align the element support to rest on the rim inside the drip bowl. If your drip bowl is equipped with a hold-down clip, align the element support opposite the terminal end with the slot in the hold-down clip, and snap into place.	23
3. After the element is positioned in the drip bowl, line up the terminal end with the terminal plug as shown.	23
4. Hold the surface element and drip bowl together as level as possible and firmly push the terminal end into the terminal plug. Make sure element terminal is seated properly into terminal plug. Make sure the surface element is level to reduce the ha...	23
Cleaning under bake element (some models)	24
Figure 16: Lift bake element	24
Cleaning under cooktop (some models) To raise the cooktop for cleaning (some models)	24
Figure 17: Lifting cooktop	24
1. Grasp the sides and lift from the front (See Figure 17). Lift-up rods will support the top in a raised position. Only lift the cook top far enough to allow the support rods to snap into place.	24
2. Clean underneath using a clean cloth and hot, soapy water.	24
Removing and Replacing the Oven Door:	25
1. Open oven door completely, horizontal with floor (See Figure 18).	25
2. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Figure 19). A tool such as a small flat-blade screwdriver may be required.	25
3. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 20).	25
4. Close the door to approximately 10 degrees from the door frame (See Figure 20).	25
5. Lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 21).	25
1. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 20).	25
2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 20 and Figure 21). The hook of the hinge arms must be fully seated onto th...	25
3. Fully open the oven door, horizontal with floor (See Figure 18).	25
4. Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges to the locked position (See Figure 19).	25
5. Close the oven door.	25
Figure 18: Door hinge location	25
Figure 19: Door hinge locks	25
Figure 20: Holding door for removal	25
Figure 21: Replacement and location of hinge arm and roller pin	25
Replacing the Oven Light	26
1. Turn electrical power off at the main source or unplug the appliance.	26
2. Replace the bulb with a new appliance bulb.	26
3. Turn the power back on again at the main source (or plug the appliance back in).	26
4. Be sure to reset the time of day on the clock.	26
Figure 22: Oven light	26
To remove and replace storage drawer (some models)	26
Figure 23: Open storage drawer	26
Figure 24: Closed storage drawer	26
Oven Baking	27
Solutions to Common Problems:	28
Cooktop Problems	29