Frigidaire FFEF3050LS Complete Owner's Guide (English) - Page 22

Care & Cleaning - stainless steel

Page 22 highlights

CARE & CLEANING Cleaning recommendation table Surface type Recommendation • Control knobs • Painted body parts • Painted decorative trim • Aluminum, plastic or vinyl trim pieces Use hot, soapy water and a cloth. Dry with a clean cloth. For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. Do not use abrasive cleaners on any of these materials; they can scratch. To remove control knobs, turn to the OFF position; grasp firmly and pull straight off the shaft. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place. • Control panel • Decorative trim (some models) Before cleaning the control panel, turn all controls OFF and if needed remove any knobs from the panel. Clean using hot, soapy water and a dishcloth. Be sure to squeeze excess water from the dishcloth before wiping the control panel; especially when wiping around the controls area. Excess water in or around the controls may cause damage to the appliance. When rinsing, use clean water and a dishcloth and be sure to squeeze excess water from dishcloth before wiping the control panel. • Stainless steel (some models) Clean heavier soils with hot, soapy water and a dishcloth. Rinse with clean water and a cloth. Do not use cleaners with high concentrations of chlorides or chlorine. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the cleaners off from the surface as bluish stains may occur during heating that cannot be removed. • Porcelain enamel broiler pan and broiler pan insert (if equipped) • Door liner & body parts Gentle scouring with a soapy non-abrasive scouring pad will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub with a soap-filled non-abrasive scouring pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or the porcelain may become damaged during future heating. • Oven racks • Oven door • Ceramic cooktop Oven racks must be removed from oven cavity. Clean by using a mild, abrasive cleaner following manufacturer's instructions. Rinse with clean water and dry. Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may use a glass cleaner on the outside glass of the oven door. Do not immerse the door in water. Do not spray or allow water or the glass cleaner to enter the door vents. Do not use oven cleaners, cleaning powders or any harsh abrasive cleaning materials on the outside of the oven door. Do not clean the oven door gasket. On self-cleaning models the oven door gasket is made of a woven material which is essential for a good seal. Care should be taken not to rub, damage or remove this gasket. Do not use spray oven cleaners on the cooktop. See cooktop cleaning and maintenance in the Care & Cleaning section. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

22
CARE & CLEANING
Surface type
Recommendation
Porcelain enamel broiler pan and broiler
pan insert
(if equipped)
Door liner & body parts
Use hot, soapy water and a cloth. Dry with a clean cloth.
For general cleaning
, use hot, soapy water and a cloth.
For more
difficult soils and built-up grease
, apply a liquid detergent directly onto
the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth
and dry.
Do not
use abrasive cleaners on any of these materials;
they can scratch. To remove control knobs, turn to the OFF position;
grasp firmly and pull straight off the shaft. To replace knobs after
cleaning, line up the flat sides of both the knob and the shaft; then
push the knob into place.
Before cleaning the control panel,
turn all controls OFF and if needed
remove any knobs from the panel. Clean using hot, soapy water and a
dishcloth.
Be sure
to
squeeze excess water from the dishcloth
before
wiping the control panel; especially when wiping around
the
controls area. Excess water in or around the controls may cause
damage to the appliance. When rinsing, use clean water and a
dishcloth and be sure to squeeze excess water from dishcloth before
wiping the control panel.
Stainless steel
(some models)
Oven racks
Oven door
Oven racks must be removed from oven cavity.
Clean by using
a mild, abrasive cleaner following manufacturer's instructions. Rinse
with clean water and dry.
Use soap & water to thoroughly clean the top, sides and front of the
oven door. Rinse well. You may use a glass cleaner on the outside
glass of the oven door.
Do not
immerse the door in water.
Do not
spray or allow water or the glass cleaner to enter the door
vents.
Do not use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door.
Do not
clean the oven door gasket. On self-cleaning models the oven
door gasket is made of a woven material which is essential for a good
seal. Care should be taken not to rub, damage or remove this gasket.
Do not
use spray oven cleaners on the cooktop. See cooktop cleaning
and maintenance in the
Care & Cleaning
section.
Ceramic cooktop
Cleaning recommendation table
Control knobs
Painted body parts
Painted decorative trim
Aluminum, plastic or vinyl trim pieces
Control panel
Decorative trim
(some models)
Clean heavier soils with hot, soapy water and a dishcloth. Rinse with
clean water and a cloth.
Do not use cleaners with high
concentrations of chlorides or chlorine.
Do not use harsh scrubbing
cleaners. Only use kitchen cleaners that are especially made for cleaning
stainless steel. Always be sure to rinse the cleaners off from the surface
as bluish stains may occur during heating that cannot be removed.
Gentle scouring with a soapy non-abrasive scouring pad will remove
most spots. Rinse with a 1:1 solution of clear water and ammonia.
If
necessary
, cover difficult spots with an ammonia-soaked paper towel
for 30 to 40 minutes. Rinse with clean water and a damp cloth, and
then scrub with a soap-filled non-abrasive scouring pad. Rinse and
wipe dry with a clean cloth. Remove all cleaners or the porcelain may
become damaged during future heating.