Frigidaire FFEW2725PS Complete Owner's Guide - Page 18
Removing and Replacing the Oven Door, To Replace Oven Door
View all Frigidaire FFEW2725PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CARE AND CLEANING Removing and Replacing the Oven Door CAUTION The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. Oven door hinge locations To remove the oven door: 1. Open oven door completely, horizontal with floor (See Figure 7). 2. Pull the door hinge locks on both left and right door hinges down from the oven frame completely toward the oven door (See Figure 8). A tool such as a small flat-blade screwdriver may be required. 3. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 9). 4. Close the door to approximately 10 degrees from the door frame (See Figure 9). 5. Lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 9). To Replace Oven Door: 1. Firmly grasp both sides of oven door along the door sides. Do not use the oven door handle (See Figure 9). 2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 9 and Figure 10). The hook of the hinge arms must be fully seated onto the roller pins. 3. Fully open the oven door, horizontal with floor (See Figure 7). 4. Push the door hinge locks up toward and into the oven frame on both left and right oven door hinges to the locked position (See Figure 8). 5. Close the oven door. Figure 7: Door hinge location LOCK Figure 8: Door hinge locks oven door about 10° hinge Figure 9: Holding door for removal IMPORTANT Special Door Care Instructions - Most oven doors contain glass that can break. Do not close the oven door until all the oven racks are fully in place. Do not hit the glass with pots, pans, or any other object. Scratching, hitting, jarring, or stressing the glass may weaken its structure causing an increased risk of breakage at a later time. roller pin hinge arm Figure 10: Replacement and location of hinge arm and roller pin 18