Frigidaire FFGF3012TW Product Specifications Sheet - Page 3
Front
View all Frigidaire FFGF3012TW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Frigidaire Baseline Freestanding Ranges FFGF3012T W/ B 30" Gas 13" max. 25" Minimum clearance (A) required to nearest combustible wall on either side of range 30"min. 30" min.* 18" min. above 36" height Wall CL 18" min. 30" 111/2" 23" 8" 36" stand. 46 5/8" 15" 101/2" 24" 2" Recommended area for 120V outlet on rear of wall and area for through-the-wall connection of pipe stub and shutoff valve Front Recommended area for through-the-floor connection of pipe stub and shutoff valve * Min. distance from cooking surface to underside of overhead cabinetry Clearance (A) Based on Largest Burner Output Rating on Cooking Surface 9,500 BTU or less 10,000-16,999 BTU 17,000 BTU or greater Minimum Clearance Required 2" 3" 5" 48 1/2" max. Side 29 1/4" 25 3/4" Gas inlet location (right bottom rear*) Power cord location (left bottom rear*) *when viewed from front Note: Overall product dimensions are model specific and may vary slightly from illustration. Refer to model's product specifications for actual dimensions. 36" (Adjustable to ±1/8") 29 7/8" Freestanding Range Specifications • Product Shipping Weight (approx.) - 160 Lbs. • Voltage Rating - 120V / 60 Hz / 5 Amps • Amps @ 120 Volts = 5 Amps • Always consult local and national electric and gas codes. • Make sure wall coverings around range can withstand heat generated by range. • Linoleum or any other synthetic floor covering located beneath range, must be capable of withstanding minimum heat of 90° F above room temperature without shrinking, warping or discoloring. Insulating pad or 1/4"-thick plywood required between range and a carpeted floor. • Do not obstruct flow of combustion air at oven vent nor around base or beneath lower front panel of range. Range requires fresh air for proper burner combustion. • Do not install range beneath any downward-blowing, overhead vent hood or air curtain. • Range ships with 3/4" factory regulator. • LP Gas Conversion Kit supplied. • Floor beneath range MUST be solid and level. • Overhead cabinetry should not exceed a 13" maximum depth. • Absolute minimum horizontal distance between overhead cabinets installed to either side of appliance must be no less than maximum width of appliance. • Range can be installed flush to wall with 0" minimum rear clearance. • Minimum clearance required (from edge of rangetop to nearest combustible wall on either side of range above 36" height) is based on largest burner output rating on cooking surface. • To reduce risk of fire when using overhead cabinetry, install range hood that projects horizontally a recommended minimum of 5" beyond bottom of cabinets. • Follow all dimension requirements provided to prevent property damage, potential fire hazard, and incorrect countertop and cabinet cuts. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FFGF3012T 03/17 © 2017 Electrolux Home Products, Inc. Specifications subject to change.