Frigidaire FFGF3054TW Complete Owner s Guide - Page 36
Replacing the Oven Light, To remove and replace storage drawer some, models
View all Frigidaire FFGF3054TW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
CARE AND CLEANING 6. Wipe the burner head clean with a soft, clean cloth, sponge, or scratch-free cleaning pad. 7. Before using the cooktop again, make sure the burner caps are properly placed and seated on the burner heads. When placed correctly, the burner cap is centered on the burner head and will click into place on the burner head. You can wiggle the cap to test placement, it should not move off the burner head (see "Assembly of the burner caps" on page 13). 7. Be sure to reset the time of day on the clock. glass shield wire holder Important notes: • The surface burner heads are secured to the cooktop and must be cleaned in place on the cooktop. • Always keep the surface burner caps in place whenever a surface burner is in use. • When replacing the burner caps, be sure the burner caps are seated firmly on top of the burner heads. • For proper flow of gas and ignition of burners do not allow spills, food, cleaning agents, or any other material to enter the gas orifice port opening. Replacing the Oven Light CAUTION Be sure the oven is unplugged and all parts are cool before replacing the oven light. Replacing the oven interior light bulb: The interior oven light is located at the rear of the oven cavity and covered with a glass shield. The glass shield must be in place whenever the oven is in use (Figure 27). 1. Turn electrical power off at the main source or unplug the appliance. 2. Remove the interior oven light shield after removing the wire holder by carefully moving the wire to the side of the glass shield. The tension from the wire holds the glass shield in place. 3. Pull the shield straight out. Do not twist or turn. 4. Replace the bulb with a new appliance bulb. 5. Replace the glass oven light shield. Replace wire holder. 6. Turn the power back on again at the main source (or plug the appliance back in). Figure 27: Oven light protected by glass shield To remove and replace storage drawer (some models) Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use care when handling the drawer. To remove the drawer: 1. Pull empty drawer out until it stops. 2. Tilt up the front of the drawer up and pull it out over the glide stop. To replace the drawer: 1. Insert the back of the drawer into the opening. 2. Lift up the drawer and line up the drawer supports with the rails. Make sure to clear the glide stop. 3. Push in the drawer until it stops. glide rail glide stop drawer support Figure 28: Parts of storage drawer 36