Frigidaire FFHI1835VS Complete Owners Guide - Page 11
Door Bearing Reversal For, Freezer and Refrigerator Doors, IMPORTANT
View all Frigidaire FFHI1835VS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11 DOOR REMOVAL IMPORTANT Place the door on a padded surface to avoid damage. 5. Unscrew the center hinge pin using an adjustable wrench and set it aside (see Figure 3). 6. Open the refrigerator door and lift the door off of the bottom hinge pin. Set the door aside. 7. Remove the 3 center hinge screws using a Phillips screwdriver and set the center hinge aside (see Figure 3). 12. Install the bottom hinge pin in the left-hand hole of the left-hand lower hinge (see Figure 6). 13. Flip the door stopper. Reinstall the door stopper on top of the bottom hinge with the screw (see Figure 6). Figure 6 Hinge Door Bearing Reversal For Pin Screws Freezer and Refrigerator Doors Hinge Hole Plug Center Hinge 1. With a flathead screwdriver, pry out the center hinge bearing from the top of the refrigerator door (see Figure 7A). Figure 3 8. Remove the 3 pan head screws on the opposite side of the center hinge (Figure 4) and install them in the holes where the center hinge was attached. 2. With a flathead screwdriver, pry out the center hinge bearing plug from the opposite side of the refrigerator door (see Figure 7B). B Figure 4 9. Remove both lower hinge covers. 10. Remove the screw from the door stopper with a Phillips screwdriver (see Figure 5). 11. Unscrew the bottom hinge pin from the right-hand position using an adjustable wrench (see Figure 5). Door Stopper Door Stopper Screw Bottom Hinge Pin Figure 5 A Figure 7 3. Install the hinge bearing on the opposite side by tapping it with a hammer until it is flush with the end cap. Repeat the process for the plug. 4. Reverse the door handle (see DOOR HANDLE INSTALLATION section if applicable). 5. Flip the refrigerator door over and remove the screw from the door closer using a Phillips screwdriver and set it aside (see Figure 8A). 6. Pry out the hinge bearing from the door with a straight screwdriver (see Figure 8B).