Frigidaire FFHP123CS2 Installation Instructions - Page 25
Initial operation test
 |
View all Frigidaire FFHP123CS2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Initial operation test Perform test operation after completing gas leak check at the flare nut connections and electrical safety check. 1. Connect the power, press the ON/OFF button on the remote controller to turn the unit on. 2. Use the MODE button to select COOL, HEAT (Only for models with heating function), AUTO and FAN to check if all the functions work well. 3. When the ambient temperature is too low(lower than 63 oF), the unit cannot be controlled by the remote controller to run in cooling mode, manual operation can be taken. Manual operation is used only when the remote controller is disable or maintenance necessary. Auto/OFF Manual control button Initial operation test 24
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20 -
21 -
22 -
23 -
24 -
25
 |
 |
Initial operation test
24
Perform test operation after completing gas leak check at the flare nut
connections and electrical safety check.
Initial operation test
1. Connect the power, press the ON/OFF button on the remote controller to turn
the unit on.
2. Use the MODE button to select COOL, HEAT (Only for models with heating
function), AUTO and FAN to check if all the functions work well.
3. When the ambient temperature is too low(lower than 63
o
F), the unit cannot
be controlled by the remote controller to run in cooling mode, manual
operation can be taken. Manual operation is used only when the remote
controller is disable or maintenance necessary.
Manual control button
Auto/
OFF