Frigidaire FFHT1514TS Product Specifications Sheet - Page 3
Top View
View all Frigidaire FFHT1514TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Baseline Top Mount Refrigerators FFHT1514T S / W / B 14.5 Cu. Ft. Top View Recessed water line Recessed (ice maker models only) electrical outlet Allow 1" min. clearance at rear for proper air circulation and water / electrical connections Allow 3/8" min. clearance at sides and top for ease of installation When installing directly adjacent to wall, sufficient handle clearance required where handle may make contact with wall, to allow for 90° door opening* * When installing refrigerator adjacent to wall, cabinet or other appliance that extends beyond front edge of unit, 20" minimum clearance recommended to allow for optimum 140° door swing, providing complete crisper access and removal. (Absolute 3" minimum clearance will ONLY allow for 90°door swing which will provide limited crisper access with restricted removal.) 29 7/8" 28" 60 5/8" with 3/8" rollers 59 7/8" with 3/8" rollers Water line inlet location (left bottom rear) 26 5/8" 31 7/8" Power cord location (right bottom rear) Allow 56" min. (with doors 90° open) Top Mount Refrigerator Specifications • Product Shipping Weight (approx.) - 175 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (NFPA 70) and local codes & ordinances. • Voltage Rating - 120V / 60 Hz • Connected Load (kW Rating) @ 120 Volts = 0.72 kW • Amps @ 120 Volts = 6.0 Amps • Always consult local and national electric & plumbing codes. • Floor should be level surface of hard material, capable of supporting fully loaded refrigerator. • Minimum 3/8" clearance required for sides and top of refrigerator with 1" clearance at rear to allow for ease of installation, proper air circulation, and plumbing / electrical connections. • When installing refrigerator adjacent to wall, cabinet or other appliance that extends beyond front edge of unit, 20" minimum clearance recommended to allow for optimum 140° door swing, providing complete crisper access and removal. (Absolute 3" minimum clearance will ONLY allow for 90° door swing which will provide limited crisper access with restricted removal.) • To ensure optimum performance, do not install in areas where temperature drops below 55° F or rises above 110° F and avoid installing in direct sunlight or close proximity to range, dishwasher or other heat source. • For proper ventilation, front grille MUST remain unobstructed. • Recess electrical outlet when possible. • Optional Ice Maker Kit (PN # IM116) available for installation in ice maker-ready models only. • Water recess on rear wall recommended to prevent water line damage. • Water Pressure - Cold water line must provide between 30 and 100 pounds per square inch (psi). • Copper tubing with 1/4" O.D. recommended for water supply line with length equal to distance from rear of unit to household water supply line plus 7 additional feet. Optional Water Supply Installation Kits available. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Ice Maker Kit - (PN # IM116). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FFHT1514T 05/17 © 2017 Electrolux Home Products, Inc. Specifications subject to change.