Frigidaire FFPA1422R1 Complete Owner's Guide - Page 10
continued, DRAINAGE
View all Frigidaire FFPA1422R1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Operating Instructions Operating Instructions (continued) temperature display. Use the same way as above to set the delay start timing by pressing TIMER ON button. To cancel the timer setting, simply tap TIMER ON or TIMER OFF button to change the timing to 0.0. SLEEP OPERATION: In this mode the selected temperature will increase by 2 °F 30 minutes after the mode is selected. The temperature will then increase by another 2 °F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" mode and the unit will continue to operate as originally programmed. The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button. Note: This feature is unavailabe under FAN or DRY modes. SWING OPERATION: When you turn on the unit, the louver will swing and stop at a certain angle. You can press the SWING button to let the louver swing automatically. Press the SWING button again while you want the louver stop at desired angle. CHECK FILTER FEATURE: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The filter indicator will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter" button and the light will go off. SELECTING FAN SPEED: AUTO LOW HIGH MED You can select the desired fan speed, by pressing the FAN SPEED button. The fan speed will change in the sequence as the drawing on the left. NOTE: After choosing the fan speed as "LOW", "MED" or "HIGH", the cooresponding fan speed indicator light will illuminate. After the AUTO fan speed is selected, no fan speed indicator light will illuminate. Under AUTO, Heat, Dry mode, you can not select the fan speed. FAULT CODE: If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "ES" , the evaporator temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "E4" , the display panel communication has failed. Contact your Authorized Frigidaire Service Center. If the display reads "P1" , bottom tray is full. Carefully move the unit to a drain location, remove the bottom drain plug and let the water drain away. Restart the machine until the "P1" symbol disappears. If error repeats, call for service. DRAINAGE: During the dehumidifying mode, you will need a garden hose (sold separately) to drain the condensate from the unit. Remove the rubber stopper from the hose connector, then screw on a garden hose to the connector as shown on fig 23. The hose may then: A. Discharge into a drain that is lower than the unit. B. Be connected to a condensate pump (sold separately). C. During cooling mode, please replace the rubber stopper to the hose connector to reach the maximum performance. Garden hose Remove the supplied rubber stopper Fig. 23 10 2009 Electrolux Home Products, Inc. All rights reserved.