Frigidaire FFRS1022R1 Installation Instructions - Page 8

8

Installation Instructions

Cut side channel seal

into 2 equal lengths. Remove the protective backing and apply it to the rear side of the

cabinet side channels, starting just below the panel frame assembly. Pinch off excess length so the seal is even with

the bottom of the cabinet side channel (FIG.29).

To remove front

as shown (FIG.30)

1.

Remove the two front retaining screws from the front frame.

2.

Press firmly on each side of the metal case close to the front, approximately 2/3 of the way down.

3.

While pressing on the sides of the metal case, gently pull the front out and lift up to release it from the case.

4.

Then release the electrical coupler plug.

NOTE:

DO NOT push or pull air direction louvers.

Place the air conditioner in the window opening as shown (FIG.31).

It should sit on the platform assembly

so that the window panel frame and the cabinet side channels are against the top and side window jambs. Side

channels should overlap side window jambs equally.

Apply side

channel

seal to side

channels just

below edge of

panel frame.

Front

Retaining

Screw

in the top window jamb in line with the partially plugged holes in the panel

necessary, two screws may be used on the sides of the panel frame as well.

Drill two screw-clearance holes

screws. When doing this, be careful not to twist the side channel seals with the screws.

NOTE:

Inserting screws will prevent the air conditioner from being pushed into the room.

To replace the front

first reconnect the coupler plugs, make the exhaust control positioned through the front

in the proper location. Gently push the front into position on the cabinet. It should click into place. Then replace the

retaining screws that holds the panel in place.

Do not

push against or pull upon the front panel louvers.

FIG.29

FIG.30

FIG.31

34

35

36

37

38

39

Frigidaire FFRS1022R1 Installation Instructions - Page 8

To replace the front

Page 8 highlights