Frigidaire FFSC2323TS Complete Owners Guide - Page 22
More about your Advanced, Water Filter, PureSource, Ultra II, PureSource Ultra II
View all Frigidaire FFSC2323TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
CHANGING THE FILTER More about your Advanced Water Filter The PureSource Ultra IITM ice and water filter system is tested and certified to NSF/ANSI Standards 42, 53 and 401 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Test & certification results: • Rated Capacity - 125 gallons/473 liters for PureSource Ultra IITM ice and water filter • Rated service flow - .65 gallons per minute • Operating Temp: Min. 33°F, Max. 100°F • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch To replace your PureSource Ultra IITM water filter: It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. 1. Turn Off the ice maker power switch. 2. Remove the old filter by rotating it counterclockwise (to the left) 90 degrees to release it. 3. Slide the old filter cartridge straight out of the housing and discard it. 4. Unpackage the new filter cartridge. Slide it into the filter housing as far as it will go with the grip end horizontal. 5. Push lightly inward on the filter while rotating it clockwise (to the right). The filter will then pull itself inward as it is rotated. Rotate the filter 90 degrees until it stops and the grip end is vertical. You may be able to feel a very light click as the filter locks into place. 6. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. 7. Continue dispensing water for 3-4 minutes or until 1.5 gallons of water has flowed through the system. You will likely need to empty and refill your glass several times. 8. Turn On the ice maker. 9. Press and hold the Water Filter reset button on the control panel for three seconds. When the display changes from Red to Green, the status has been reset. 22