Frigidaire FFTA1033S1 Product Specifications Sheet - Page 3

Frigidaire Baseline Home Comfort FFTA1033S1 Through-The-Wall Air Conditioner Through-The-Wall Installation Wall (thickness) 14 1/2" 18" max. 20 1/2" 24" Through-The-Wall 18" Sleeve Kit (PN # EA108T) Outside closure panel Wall Adjustable mounting brackets Locking clip Sleeve-to-unit seal Building construction support Inside closure panel Plug Type (NEMA) 5-15P Home Comfort Specifications • Product Shipping Weight (approx.) - 80 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (ANSI/NFPA 70) and local codes & ordinances. • Voltage Rating - 115V / 60 Hz / 15 Amps • Amps @ 115 Volts = 8.3 Amps • Recommended Circuit Breaker - 15 Amps • Unit equipped with 115V 3-wire power supply cord, NEMA plug type 5-15P, approximately 72" long. • Unit's increased performance characteristics result from two rear intakes. For unit to operate at maximum efficiency, carefully follow complete, detailed new or replacement installation instructions provided in Product Installation Guide on web. • Unit requires rearward slope when installation is complete, to allow condensate to drain from rear of sleeve. New Installation • For new installation, Frigidaire® Through-The-Wall 18" Sleeve Kit PN # EA108T available. Recommended for proper installation. • Through-the-wall installation requires 18" maximum wall thickness. • For energy-saving purposes, install unit in shady location, preferably a northern exposure; and do not block airflow inside with blinds, curtains or furniture; or outside with shrubs, enclosures or other buildings. Replacement Installation • When replacing existing air conditioner with new unit, refer to Product Installation Guide on web to identify existing wall-sleeve manufacturer and size compatibility. If proper installation and slope are suspect, then correct installation of Frigidaire® Through-The-Wall 18" Sleeve Kit PN # EA108T recommended. • Use of existing wall sleeve to mount new unit requires original sleeve be in sound structural condition with rear grille that attaches securely, or rear flange that serves as stop for unit. • Preferable installation option, for increased efficiency and possibility of drafts reduced, requires existing rear grille (mounted to sleeve) be replaced with new unit's rear air-directional louvered grille (provided in accessory kit, shipped with unit). Non-preferable installation option of directly mounting rear louvered grille to unit can be considered, requiring grille be mounted to unit prior to sleeve installation. • Existing decorative exterior grille may be left in place, provided that proper air-directional rear louvered grille is installed. • For installation into larger existing sleeve, optional Trim Kit PN # EA120T available. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Through-The-Wall 18" Sleeve Kit - (PN # EA108T). • Trim Kit (for larger existing sleeve) - (PN # EA120T). • Architectural-Style Exterior Louvered Grille - (PN # EA109T). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FFTA1033S1 01/16 © 2016 Electrolux Home Products, Inc. Specifications subject to change.