Frigidaire FFTA103WA1 Complete Owners Guide - Page 9
Timer: Delay Stop/start Feature, You Will See How Much Time Is Chosen - 24
View all Frigidaire FFTA103WA1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Operating Instructions (continued) TIMER: DELAY STOP/START FEATURE Operating Instructions YOU WILL SEE HOW MUCH TIME IS CHOSEN: THEN DO THIS: PRESS UP/DOWN BUTTONS FIRST DO THIS: PRESS TIMER BUTTON REMOTE SENSING FEATURE (on some models)ğ To delay stop(or start), press the Timer button when the unit is power-on(or power-off), then the "timer off" indicator(or "timer on" indicator) will illuminate. Then adjust timer setting, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The setting will be confirmed automatically in 5 seconds, then the control will count down the time(8, 7.5, 7, etc.) left, and all other settings will remain the same as they were before the timer setting is confirmed, until stop(or start). Setting combination of "delay stop turn off delay start" or "delay start turn on delay stop" is workable. Both "timer off" indicator and "timer on" indicator will illuminate then. The timer setting can be canceled by either pressing and holding the timer button for 2 seconds, or pressing the power on/off button at any time to turn off the unit directly. Remote Sensing indicator DO THIS: PRESS REMOTE SENSING BUTTON NOTE: Unit display shows the set temperature NOTE: Remote display is actual temperature Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. at remote control only To activate the remote sensing feature, point the remote control towards the unit and press the Remote Sensing button. Next, use the " " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will illuminate to indicate it receives the signal. The LIGHT on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing button again. lf the unit does not receive the remote sensing signal during any 7 minute interval, the Remote Sensing feature will halt until the unit receives signal from the remote control again. The display on the remote control indicates the temperature at the remote ONLY. NOTE: The Remote Sensing function can be terminated either by pressing the Remote Sensing button again or the main ON/OFF button on the unit. 2009 Electrolux Home Products, Inc. All rights reserved. 9