Frigidaire FFUH17F2NW Use and Care Guide - Page 5

To Level Upright Models: After discarding crating screws and wood base, use a carpenter's level to level the freezer from front-to-back. Adjust the plastic leveling feet in front, ½ bubble higher, so that the door closes easily when left halfway open. To Level Chest Models: If needed, add metal or wood shims between foot pads and floor. INSTALLATION Turn Left To Raise Shelf Front Turn Right To Lower Plastic Leveling Feet Crating Screw Door Removal (non-electronic models) If door must be removed: 1. Gently lay freezer on its back, on a rug or blanket. 2. Remove two base screws and base panel. 3. Remove bottom hinge screws. 4. Remove plastic top hinge cover. 5. Remove screws from top hinge. Discard The (4) Crating Screws And (2) Wood Bases Unpacking and Leveling -- Upright Models Cleaning (prior to use) • Wash any removable parts, the freezer interior, and exterior with mild detergent and warm water. Wipe dry. Do not use harsh cleaners on these surfaces. 6. Remove top hinge from cabinet. 7. Remove door and bottom hinge from cabinet. 8. To replace door, reverse the above order and securely tighten all screws to prevent hinge slippage. Door Removal (electronic models) • Do not use razor blades or other sharp instruments, which can scratch the appliance surface when removing adhesive labels. Any glue left from the tape can be removed with a mixture of warm water and mild detergent, or touch the residue with the sticky side of tape already removed. Do not remove the serial plate. If door must be removed: Door hinge is fastened with tamper-proof screws. Please have a qualified technician remove the door. CAUTION To allow door to close and seal properly, DO NOT let food packages extend past the front of shelves. 5