Frigidaire FG4H2272UF Complete Owners Guide - Page 27
More about the Advanced Water, Filter
View all Frigidaire FG4H2272UF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
CHANGING THE FILTER More about the Advanced Water Filter The PureSource Ultra IITM ice and water filter system is tested and certified to NSF/ANSI Standards 43, 53 and 401 for the reduction of claims specified on the performance data sheet. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. Test & certification results: • Rated Capacity - 125 gallons/473 liters for PureSource Ultra IITM ice and water filter • Rated service flow - .65 gallons per minute • Operating Temp: Min. 33°F, Max. 100°F • Maximum Rated Pressure - 100 pounds per square inch • Recommended Minimum Operating Pressure: 30 pounds per square inch To replace the PureSource Ultra IITM water filter: It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement. (Instructional video of procedure can be found on www.frigidaire.com.) 1 Push down on front edge of filter cover. Cover will tilt down and expose water filter. 2 Remove the old filter by rotating it counter-clockwise (to the left) 90 degrees to release it. 3 Slide the old filter cartridge straight out of the housing and discard it. 4 Unpackage the new filter cartridge. Slide it into the filter housing as far as it will go with the grip end horizontal. 5 Push lightly inward on the filter while rotating it clockwise (to the right). The filter will then pull itself inward as it is rotated. Rotate the filter 90 degrees until it stops and the grip end is vertical. A very light click may be heard as the filter locks into place. 6 Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal. 7 Continue dispensing water for 3-4 minutes. It may be necessary to empty and refill the container several times. 8 Press and hold the Reset Water Filter button on the display for three seconds. When indicator is no longer illuminated, the water filter status has been reset. 9 Replace filter cover by pushing up and snapping into place. 27