Frigidaire FGBC5334VS Complete Owners Guide - Page 7

Button Plugs 3 pcs, Upper Left Hinge

Page 7 highlights

Button Plugs (3 pcs) INSTALLATION 7. Unscrew hinge pin from bottom hinge and transfer to threaded hole on opposite side. (See Figure 7.) Reinstall bottom hinge in left hand corner of cabinet using same three screws removed in Step 6. Pin Plastic Grille Insert Screws Hinge Figure 7 Transfer the plastic grille insert to the gap on the opposite side. Figure 4 5. Install new left hand top hinge (prepackaged inside unit) at the left hand cabinet corner. (See Figure 5.) 8. On bottom edge of door, transfer door stop bracket and bushing to holes on opposite side. (See Figure 8.) cShteaprt83:)Remove tahnedstchreewb,tlohcekn set them on the left side.(see S⑦top Bra⑧cket Bus⑥hing Step 9:Change thefrFhoiimnggutehreaexri8sght hole to left hole(see chart 4 Upper Left Hinge Figure 5 9. Place bottom left hand corner of door onto lower hinge then tilt top of door back to clear edge of top hinge. Make sure door is level and it seals properly against cabinet then insert hinge pin through hole in top hinge and into door busing. Securely fasten with Phillips screwdriver. (See Figure 9.) 6. Remove three screws that hold the bottom hinge to lower end of cabinet. (See Figure 6.) Hinge Pin Top Hinge Hinge Screws Figure 6 Figure 9 10. Reinstall toe grille using same screws removed in Step 4. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

Figure 5
Upper Left Hinge
5. Install new left hand top hinge
(prepackaged inside unit) at the left hand
cabinet corner. (See Figure 5.)
Screws
Hinge
Pin
Figure 7
Stop
Bracket
Bushing
Figure 8
Hinge Pin
Top Hinge
Figure 9
7. Unscrew hinge pin from bottom hinge and
transfer to threaded hole on opposite side.
(See Figure 7.) Reinstall bottom hinge in
left hand corner of cabinet using same
three screws removed in Step 6.
8. On bottom edge of door, transfer door
stop bracket and bushing to holes on
opposite side. (See Figure 8.)
9. Place bottom left hand corner of door onto
lower hinge then tilt top of door back to
clear edge of top hinge. Make sure door is
level and it seals properly against cabinet
then insert hinge pin through hole in top
hinge and into door busing.
Securely
fasten with Phillips screwdriver.
(See Figure 9.)
6. Remove three screws that hold the bottom
hinge to lower end of cabinet. (See Figure 6.)
10. Reinstall toe grille using same screws
removed in Step 4.
Figure 4
Button Plugs (3 pcs)
Plastic
Grille
Insert
Transfer the plastic grille insert to
the gap on the opposite side.
Figure 6
Screws
Hinge
7
INSTALLATION