Frigidaire FGDS3065KB Complete Owner's Guide (English) - Page 13
To assemble the Effortless™ Oven Rack system
UPC - 057112102917
View all Frigidaire FGDS3065KB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
BEFORE SETTING OVEN CONTROLS The Effortless™ oven rack system Some models are equipped with a special oven rack system that automatically partially extends the oven rack from the interior oven glides to assist in easier access to your food items. This feature works whenever the oven door is opened or closed. To assemble the Effortless™ Oven Rack system: 1. Locate all required parts. You will need the supplied oven rack (Effortless™ Oven Rack is a flat rack with a special dark coating on the left and right rack sides) and the 2 supplied chrome connector arms. 2. Open the oven door. Be sure the oven is completely cool before proceeding. 3. Place the oven rack in positions 1, 2 or 3 only (see previous page to verify positions). Be sure the rack connector brackets are at the rear of the range and pointing towards oven bottom (See Figure 2). 4. Assemble one connector arm at a time. With the oven door open and the oven rack in place, install one end of the connector arm to the hole in the door connector bracket (Figure 1) and the other end in the hole in the rack connector bracket (Figure 2 and as in Figure 3). The oven rack may need to be adjusted in or out in the rack position to match the length of the connector arm. 5. While holding the connector arm in place, twist the connector arm so the ends of the connector arm point upwards (See Figures 4 & 5). The connector arm should now be locked into position. 6. Repeat steps 4 and 5 for the other connector arm. 7. Once both connector arms are properly in place, be sure to test the oven rack operation by gently closing the oven door. The oven rack should move in and out of the oven freely when the door is opened or closed. CAUTION REMOVE ALL OVEN RACKS and parts before starting a self-clean cycle. If the oven racks are left in the oven during the self-clean cycle, the glide ability of the Effortless Oven Rack system will be damaged and will cause all oven racks to loose their shiny finish and or turn blue. Remove ALL oven racks and clean according to instructions provided in the Care & Cleaning section of this manual. Make sure the oven and oven racks are COMPLETELY cooled and safe to touch before attempting to assemble or disassemble the Effortless™ Oven Rack system. Never pick up hot oven rack parts. Door connector bracket Rack connector bracket Figure 2 Figure 1 Connector arm Oven rack Open oven door Connector arm Figure 3 - Assembly of the EffortlessTMoven rack Connector arm Figure 4 Connector arm Left and right door connector brackets with connector arm ends shown in locked position (pointing upwards) Figure 5 Figure 6 - Effortless™ oven rack after assembly 13