Frigidaire FGEW276SPF Product Specifications Sheet - Page 3

Single Wall Ovens FGEW276SP F / B 27" Electric 27" 29" (includes 1" bottom trim) 1 1/2" min. 27 1/8" min. 24 5/8" Power supply location (left 27 1/4" bottom min. rear) 28 1/4" max. 27 1/4" 24 7/8" min. 25 1/4" max. 2"-wide wood spacers (if needed)** 23 1/2" min.* (critical dimension) 4" x 4" opening to route armored cable Full base required to support 150 lbs. Allow at least 27 1/4" clearance for reversible door depth when open 24 7/8" *Critical dimension - MUST be applied ** For cutout height greater than 28 1/4" add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven's 1"-high bottom trim will hide shims at bottom. (Optional 3"-high bottom trim available for cutout height greater than 29.) 31" suggested distance 4 1/2" min. required 2" min. 3" Electrical junction box location Single Wall Oven Specifications • Product Shipping Weight (approx.) - 130 Lbs. • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • Connected Load (kW Rating) @ 240 / 208 Volts = 3.7 / 2.8 kW • Amps @ 240 / 208 Volts = 15.4 / 13.4 Amps • Recommended Circuit Breaker - 20 Amps • Always consult local and national electric codes. • Minimum 27-1/4" clearance for oven door depth when open. • Suggested distance from floor is 31". Minimum required distance is 4-1/2". • Minimum 23-1/2" deep cutout dimension is critical for proper installation, to ensure that oven's faceplate will fit flush against cabinet front. • To adapt oven to fit cutout height greater than 28-1/4", add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven's 1"-high bottom trim will hide shims at bottom. (Standard 1"-High Bottom Trim included.) • To adapt oven to fit cutout height greater than 29", optional 3"-High Bottom Trim available. • Full oven base of solid plywood or similar material required, capable of supporting 150 Lbs. • Base must be level and cabinet front must be square. • Single Wall Ovens are NOT approved to be used in stackable or side-by-side installation. • Single Wall Ovens are approved to be used alone in under-counter installation or beneath any approved Frigidaire® gas or electric cooktop. (Refer to Gas or Electric Cooktop Installation Over 30" / 27" Electric Single Wall Oven Specifications pages on web.) • Single Wall Ovens are approved to be used in combination with any Frigidaire® Warmer Drawer. (Refer to model-specific Warmer Drawer product page for Combination Installation Specifications.) • Single Wall Ovens are approved to be used in combination with any Frigidaire® Built-In Microwave Oven. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • 3"-High Stainless Steel Bottom Trim - (PN # 903114-901S). • 3"-High Black Bottom Trim - (PN # 903114-9010). • 10'-Long Armored Power Cable ­- (PN # 903056-9010). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FGEW276SP 10/15 © 2015 Electrolux Home Products, Inc. Accessories information available on the web at frigidaire.com Specifications subject to change.