Frigidaire FGHC2342LF Use and Care Manual - Page 18

Ice Maker/Dispenser Tips, Turning the SIDE MOUNTED Ice, Maker On and Off, Turning the REAR MOUNTED - manual

Page 18 highlights

AUTOMATIC ICE & WATER DISPENSER Turning the SIDE MOUNTED Ice Maker On and Off To begin ice production, lower the wire signal arm to the DOWN or ON position. The ice maker turns off automatically when the ice container becomes full. To stop the ice maker, raise the wire signal arm until it clicks and locks in the UP or OFF position. Turning the REAR MOUNTED Ice Maker On and Off Ice production is controlled by the ice maker's ON/OFF power switch. To gain access to the ice maker, pull the ice cream shelf out. Press the switch to the "O" position to turn it Off and press it to the "I" position to turn it On. The ice maker also has a built-in wire signal arm, which automatically stops ice production when the ice bin is full. DO NOT use this signal arm to manually stop the ice maker. ON IMPORTANT Small ice cubes or ice chips jamming in the ice maker may be a sign that your water filter needs changing. If you have a side mounted ice maker you may also experience hollow cubes partially frozen cubes with water inside. When these cubes are harvested, they break open and spill water over the other ice cubes in the ice container, forming a solid mass of ice. As the water filter nears the end of its useful life and becomes clogged with particles, less water is delivered to the ice maker during each cycle. The ice maker can't fill every cube in the ice maker mold, leading to small cubes or chips that can get caught between the ice ejector blades and the stripper. Remember, if your ice maker is jamming with small ice cubes or it's been six months or longer since you last changed your water filter replace the water filter with a new one. Poor quality household water may require the filter to be changed more frequently. OFF Wire Signal Arm Off On Wire Signal Arm Ice Maker/Dispenser Tips • Ice cubes stored too long may develop an odd flavor. Empty the ice container as explained below. • Occasionally shake the ice container to keep ice separated. • If your refrigerator is not connected to a water supply or the water supply is turned off, turn Off the ice maker. • If you need a large quantity of ice at one time, it is best to get cubes directly from the ice container. • The following sounds are normal when the ice maker is operating: - Motor running - Ice dropping into ice container - Water valve opening or closing - Ice loosening from tray - Running water 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

IMPORTANT
Small ice cubes or ice chips jamming in the
ice maker may be a sign that your water
filter needs changing. If you have a side
mounted ice maker you may also experience
hollow cubes partially frozen cubes with
water inside. When these cubes are
harvested, they break open and spill water
over the other ice cubes in the ice container,
forming a solid mass of ice. As the water
filter nears the end of its useful life and
becomes clogged with particles, less water is
delivered to the ice maker during each cycle.
The ice maker can’t fill every cube in the ice
maker mold, leading to small cubes or chips
that can get caught between the ice ejector
blades and the stripper. Remember, if your
ice maker is jamming with small ice cubes or
it’s been six months or longer since you last
changed your water filter replace the water
filter with a new one. Poor quality household
water may require the filter to be changed
more frequently.
18
AUTOMATIC ICE & WATER DISPENSER
Ice Maker/Dispenser Tips
Ice cubes stored too long may develop
an odd flavor. Empty the ice container as
explained below.
Occasionally shake the ice container to
keep ice separated.
If your refrigerator is not connected to a
water supply or the water supply is turned
off, turn Off the ice maker.
If you need a large quantity of ice at one
time, it is best to get cubes directly from
the ice container.
The following sounds are normal when the
ice maker is operating:
- Motor running
- Ice dropping into ice container
- Water valve opening or closing
- Ice loosening from tray
- Running water
Turning the SIDE MOUNTED Ice
Maker On and Off
To begin ice production, lower the wire signal
arm to the DOWN or ON position. The ice
maker turns off automatically when the ice
container becomes full. To stop the ice maker,
raise the wire signal arm until it clicks and
locks in the UP or OFF position.
Turning the REAR MOUNTED Ice
Maker On and Off
Ice production is controlled by the ice maker’s
ON/OFF power switch. To gain access to the
ice maker, pull the ice cream shelf out. Press
the switch to the “O” position to turn it Off and
press it to the “I” position to turn it On. The
ice maker also has a built-in wire signal arm,
which automatically stops ice production when
the ice bin is full. DO NOT use this signal arm
to manually stop the ice maker.
Wire
Signal Arm
Off
On
ON
OFF
Wire
Signal Arm