Frigidaire FGHD2433KF Complete Owner's Guide (English) - Page 18

Cycle Takes a Long Time - not draining

Page 18 highlights

SOLUTIONS TO COMMON DISHWASHING PROBLEMS Dishwasher Does Not Drain Properly • If unit is hooked up to a food waste disposer, make sure the disposer is empty. • Check to see if the knockout plug has been removed from inside the food waste disposer inlet. • Check to see if drain hose is kinked. • Make sure cycle is complete, not in a pause. Dishwasher Won't Fill • Is water supply turned on? • Does overfill protector move up and down freely? (See Overfill Protector section.) Dishwasher Has an Odor • Soiled dishes left in dishwasher too long can create an odor. Use Rinse & Hold cycle. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly. (See Dishwasher Does Not Drain Properly.) Cycle Takes a Long Time • Is cycle in a water heating delay? • Has the delay start option been selected? • Has the sanitize option been selected? Stains on Tub Interior • Washing large amounts of dishware with tomato based soil can cause a pink/orange apperance. This will not affect performance and will gradually fade over time. Pre-rinsing or using the Rinse & Hold cycle will reduce the chance of staining. Using no heat dry option will lessen staining. Removing Spots and Film Hard water can cause lime deposit buildup on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons. (See Glassware/Flatware Spotted or Cloudy section.) To remove buildup, spots and film, clean using the following instructions: 1. Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware. 2. Do not add detergent. 3. Select the NORMAL WASH cycle. Close and latch door. Press START/CANCEL pad. 4. Allow dishwasher to run until it starts the second water fill (approximately 10 minutes). The SENSING light will be off. 5. Unlatch and open door and pour 2 cups of white vinegar into the bottom of dishwasher. 6. Close and latch door and allow cycle to finish. NOTE If these conditions persist, a home water softener should be considered. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

18
SOLUTIONS TO COMMON DISHWASHING PROBLEMS
not affect performance and will gradually fade over
time. Pre-rinsing or using the Rinse & Hold cycle will
reduce the chance of staining. Using no heat dry
option will lessen staining.
Removing Spots and Film
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses may also
get spots and film for a number of reasons. (See
Glassware/Flatware Spotted or Cloudy section.) To
remove buildup, spots and film, clean using the following
instructions:
1.
Load clean dishes and glasses in normal manner. Do
not load any metal utensils or silverware.
2.
Do not add detergent.
3.
Select the NORMAL WASH cycle. Close and latch
door. Press START/CANCEL pad.
4.
Allow dishwasher to run until it starts the second
water fill (approximately 10 minutes). The SENSING
light will be off.
5.
Unlatch and open door and pour 2 cups of white
vinegar into the bottom of dishwasher.
6.
Close and latch door and allow cycle to finish.
NOTE
If these conditions persist, a home water softener should
be considered.
Stains on Tub Interior
Washing large amounts of dishware with tomato based
soil can cause a pink/orange apperance.
This will
Dishwasher Does Not Drain
Properly
If unit is hooked up to a food waste disposer, make
sure the disposer is empty.
Check to see if the knockout plug has been removed
from inside the food waste disposer inlet.
Check to see if drain hose is kinked.
Make sure cycle is complete, not in a pause.
Dishwasher Won’t Fill
Is water supply turned on?
Does overfill protector move up and down freely?
(See Overfill Protector section.)
Dishwasher Has an Odor
Soiled dishes left in dishwasher too long can create
an odor. Use Rinse & Hold cycle.
There will be a “new” smell when first installed. This
is normal.
Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly.)
Cycle Takes a Long Time
Is cycle in a water heating delay?
Has the delay start option been selected?
Has the sanitize option been selected?