Frigidaire FGHT2046QF Complete Owner's Guide - Page 7

DOOR REMOVAL/REVERSAL INSTRUCTIONS 7. Remove three screws on bottom hinge and anti-tip bracket (if equipped) with ⅜" socket wrench. 8. Install bottom hinge and anti-tip bracket (if equipped) on opposite side with the three screws removed from step 7. 9. Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to other hole in hinge and tighten with adjustable wrench. 10. Reverse door handles (see Handle Installation section). 11. Move freezer and refrigerator door stops to opposite side. Before starting screws, use an awl to puncture the foam. 12. Position refrigerator door onto bottom hinge pin and screw center hinge pin through center hinge into top of door. Close refrigerator door to help align hinge hole. 13. Tighten center hinge pin with adjustable wrench. 14. Remove cabinet and hinge hole plugs and move to opposite side. 15. Lower freezer door onto center hinge pin. 16. Close freezer door. Have an assistant lift up on opposite side of door while tightening screws to install top hinge. 17. There are two toe grille covers provided in your literature packet; one for the right side and one for the left side. Install the appropriate cover over the opening on the side opposite the anti-tip bracket, (see Figures A & B).  NOTE In case of future door reversals, save the toe grille cover not being used. 18. Flip toe grille and reinstall (some models). 19. Plug in electrical power cord and turn refrigerator temperature control to center position. Adjust setting as necessary. WARNING When reversing the door swing: You MUST move the anti-tip bracket to align with the hinges of the door and install the toe grille support for proper blance. Failure to do so will result in injury. Door Stop Screw Door Stop Washer Hinge Pin Bottom Hinge Screws Toe Grille OR Anti-tip Bracket Lower Anti-tip Bracket Toe Grille Support Toe Grille Cover A Toe Grille Support Toe Grille Cover Anti-tip Bracket B 7