Frigidaire FGID2479SF Complete Owner s Guide - Page 17

Before You Call - review

Page 17 highlights

BEFORE YOU CALL Winterizing A dishwasher left in an unheated place should be protected from freezing. Have a qualified person do the following: Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that are not the result of defective workmanship or material in your dishwasher. To Disconnect Service: 1. Turn off electrical power to the dishwasher at the supply source by removing fuses or tripping circuit breaker. 2. Shut off water supply. 3. Place a pan under the inlet valve. Disconnect water line from the inlet valve and drain into pan. 4. Disconnect drain line from pump and drain water into pan. To Restore Service: 1. Reconnect the water, drain, and electrical power supply. Food Soils Left on Dishes • Choose another cycle for longer washing time. • Choose the Hi-Temp Wash option. • Check rack loading section for proper loading-avoid nesting items. • Home water pressure may be too low should be 20 to 120 pounds per square inch (psi). • Check incoming water temperature. It should be at least 120oF (49oC). (See Factors Affecting Performance.) • Check water hardness. For extremely hard water, it may be necessary to install a water softener. (See Detergent Chart). 2. Turn on water and electrical power supply • Use Fresh Detergent. 3. Fill detergent cup and run the dishwasher through a HEAVY cycle. • Make sure items are not blocking the spray arms, preventing them from rotating. 4. Check connections to make sure they do not leak. CAUTION Property Damage Hazard Freezing temperatures may cause water lines to rupture. Be sure all supply lines to and circulating lines within dishwasher are protected. Failure to do so could result in property damage. Dishes not Dry • Select heat dry option. • Make sure the rinse aid dispenser is filled. • Increase the discharge setting of rinse aid. (See Rinse Aid). • Check the incoming water temperature. Be sure it is at least 120oF (49oC). • Check for proper loading-avoid nesting items. • Plastic items may need to be towel dried. • Cups with a concave bottom will collect water. Load them at the far left of the upper rack so they will be held in a tilted position. NOTE See Installation Instructions for more details on disconnecting and restoring service to your dishwasher. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

CAUTION
Winterizing
A dishwasher left in an unheated place should be
protected from freezing.
Have a qualified person
do the following:
To Disconnect Service:
1.
Turn off electrical power to the dishwasher
at the supply source by removing fuses or
tripping circuit breaker.
2.
Shut off water supply.
3.
Place a pan under the inlet valve.
Disconnect
water line from the inlet valve and drain into
pan.
4.
Disconnect drain line from pump and drain
water into pan.
To Restore Service:
1.
Reconnect the water, drain, and electrical
power supply.
2.
Turn on water and electrical power supply
3.
Fill detergent cup and run the dishwasher
through a HEAVY cycle.
4.
Check connections to make sure they do not
leak.
Property Damage Hazard
17
BEFORE YOU CALL
NOTE
See Installation Instructions for more details
on disconnecting and restoring service to your
dishwasher.
°
Before calling for service, review this list.
It may save you both time and expense.
This list includes common experiences that
are not the result of defective workmanship
or material in your dishwasher.
Food Soils Left on Dishes
Choose another cycle for longer washing
time.
Choose the Hi-Temp Wash option.
Check rack loading section for proper
loading-avoid nesting items.
Home water pressure may be too low -
should be 20 to 120 pounds per square inch
(psi).
Check incoming water temperature.
It
should be at least 120
o
F (49
o
C). (See Factors
Affecting Performance.)
Check water hardness.
For extremely hard
water, it may be necessary to install a water
softener. (See Detergent Chart).
Use Fresh Detergent.
Make sure items are not blocking the spray
arms, preventing them from rotating.
Select heat dry option.
Make sure the rinse aid dispenser is filled.
Increase the discharge setting of rinse aid.
(See Rinse Aid).
Check the incoming water temperature.
Be
sure it is at least 120
o
F (49
o
C).
Check for proper loading-avoid nesting
items.
Plastic items may need to be towel dried.
Cups with a concave bottom will collect
water.
Load them at the far left of the
upper rack so they will be held in a tilted
position.
Dishes not Dry
Freezing temperatures may cause water
lines to rupture.
Be sure all supply lines to
and circulating lines within dishwasher are
protected.
Failure to do so could result in property
damage.