Frigidaire FGMO205KF Wiring Diagram (All Languages) - Page 1

MAGNETRON Publication No: 5995541546 FGMO205K / FPMO209K WIRING SCHEMATIC SCHEMATIC NOTE: CONDITION OF OVEN 1. Door Closed 2. CLOCK APPEARS ON DISPLAY Note:* Indicates component CAVITY MAGNETRON TEMPERATURE TEMPERATURE FUSE RED FUSE ORG ORG N.O. RED RED COM. B2 GRN GRN GRN DOOR SENSING SWITCH RED "TO LOAD" BLK "TO SOURCE" MONITOR FUSE (20A) H GRN 120VAC GND C2 60Hz N R2 C1 C3 NOISE FILTER GRY N.O. (RY1) COM. OVEN LAMP RELAY (RY2) SECONDARY INTERLOCK RELAY CONTROL UNIT PNK B1 F3 HUMIDITY SENSOR F2 F1 ORG ORG BRN ORG OL OVEN LAMP TURN TTM TABLE MOTOR MONITOR SWITCH FM FAN MOTOR N.C. COM. WHT WHT WHT WHT "TO SOURCE" "TO LOAD" GRY COM. N.O. NOTES: GRY WHT WHT PRIMARY WHT INTERLOCK SWITCH 1.CIRCUITS SUBJECT TO CHANGE WITHOUT NOTICE. 2. TERMINAL WITH PROJECTION OR OPPOSITE BLUE MARK ON LAMP SOCKET MUST BE CONNECTED TO NEUTRAL WIRE. 3. ONLY CERTAIN MODELS USE THE ABSOLUTE HUMIDITY SENSOR. 4. POWER TRANSFORMER TOP (FINISH LEAD) TERMINAL MUST BE CONNECTED TO THE NEUTRAL (WHT) WIRE. BRN ORG GRN RED RED WHT WHT WHT WHT POWER TRANSFORMER HIGH VOLTAGE CAPACITOR xx µF HIGH VOLTAGE RECTIFIER Figure O-1 Oven Schematic - Off Condition SCHEMATIC NOTE: CONDITION OF OVEN 1. DOOR CLOSED 2. COOKING TIME PROGRAMMED 3. VARIABLE COOKING CONTROL "HIGH" 4. "START" PAD TOUCHED BLK H GRN 120VAC GND 60Hz N R2 C1 MONITOR FUSE (20A) "TO SOURCE" CAVITY MAGNETRON TEMPERATURE TEMPERATURE FUSE RED FUSE ORG ORG N.O. RED RED COM. B2 GRN GRN GRN DOOR SENSING SWITCH RED "TO LOAD" C2 C3 NOISE FILTER GRY N.O. (RY1) COM. OVEN LAMP RELAY (RY2) SECONDARY INTERLOCK RELAY CONTROL UNIT PNK B1 HUMIDITY SENSOR F3 F2 F1 ORG ORG BRN ORG OL OVEN LAMP MONITOR TTM TURN TABLE MOTOR FM SWITCH FAN MOTOR N.C. COM. WHT WHT WHT BRN ORG GRN RED RED POWER TRANSFORMER HIGH VOLTAGE CAPACITOR xx µF HIGH VOLTAGE RECTIFIER WHT WHT WHT WHT WHT "TO SOURCE" "TO LOAD" GRY COM. N.O. GRY WHT WHT PRIMARY WHT INTERLOCK NOTES: SWITCH 1.CIRCUITS SUBJECT TO CHANGE WITHOUT NOTICE. 2. TERMINAL WITH PROJECTION OR OPPOSITE BLUE MARK ON LAMP SOCKET MUST BE CONNECTED TO NEUTRAL WIRE. 3. ONLY CERTAIN MODELS USE THE ABSOLUTE HUMIDITY SENSOR. 4. POWER TRANSFORMER TOP (FINISH LEAD) TERMINAL MUST BE CONNECTED TO THE NEUTRAL (WHT) WIRE. Figure O-2 Oven Schematic - Cooking Condition MAGNETRON 06/09 6