Frigidaire FGMV155CTF Installation Instructions - Page 22

Mount The Microwave, Oven Cont., C5. Installing Or Change, The Charcoal Filter, Some Models

Page 22 highlights

Installation Instructions C4. MOUNT THE MICROWAVE OVEN (cont.) 5 Insert 2 self-aligning screws through outer top cabinet holes. Turn two full turns on each screw. 2 Open the microwave door and remove the two vent mounting screws l; ocated on top of the microwave using a #1 Phillips screwdriver. Charcoal Filter 6 Tighten center screw completely. 7 Tighten the outer two screws to the top of the microwave oven. (While tightening screws, hold the microwave oven in place against the wall and the top cabinet.) 8 Install grease filters. See the Use a& nd Care packed with the microwave. C5. INSTALLING OR CHANGE THE CHARCOAL FILTER (Some Models) NOTE: The charcoal filter is factory installed in some models. Refer to the Use and Care to see if yours is factory installed and for replacement information. Follow these steps to replace or install a charcoal filter. 1 Unplug microwave oven or disconnect power. 3 Tip forward. Lift out to remove vent. 4 Install the charcoal filter. )NSERT 5 Reinstall the vent by sliding the bottom of the vent into place. Push the vent top into position and slide right into place. Replace the two vent mounting screws located on top of the microwave using a #1 Phillips screwdriver. 6 Close the microwave door. Plug in microwave oven or reconnect power. IMPORTANT: Remove the cardhoard spacers between heat shield and door. EN-22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72

Installation Instructions
5
MOUNT THE MICROWAVE
OVEN (cont.)
8
7
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
packed with the microwave.
C4.
Tighten center
screw completely.
Install grease filters. See the Use &
and Care
6
EN-22
C5. INSTALLING OR CHANGE
THE CHARCOAL FILTER
(Some Models)
Unplug microwave oven or disconnect power.
1
NOTE: The charcoal filter is factory installed in some
models. Refer to the Use and Care to see if yours is
factory installed and for replacement information.
Follow these steps to replace or install a charcoal filter.
C
lose the microwave door. Plug in microwave
oven or reconnect power.
Tip forward. Lift out to remove vent.
3
Open the microwave door and remove the two
vent mounting screws ;
located on top of the
microwave using a #1 Phillips screwdriver.
2
Install the charcoal filter.
4
5
6
Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
and slide right into place. Replace the two vent
mounting screws located on top of the microwave
using a #1 Phillips screwdriver.
Charcoal
Filter
IMPORTANT: Remove the cardhoard spacers between
heat shield and door.