Frigidaire FGRC1244T1 Installation Instructions

Frigidaire FGRC1244T1 Manual

Get Frigidaire FGRC1244T1 PDF manuals and user guides View all Frigidaire FGRC1244T1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FGRC1244T1 manual content summary:

  • Frigidaire FGRC1244T1 | Installation Instructions - Page 1
    inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended period of time. Handle air conditioner with care. Make sure air conditioner does not fall during installation. NOTE: SAVE CARTON and these INSTALLATION INSTRUCTIONS for future
  • Frigidaire FGRC1244T1 | Installation Instructions - Page 2
    FIG. 3. D. Slide the panel all the way in and repeat on the other side. FIG. 1 FIG. 2 "T" section FIG. 3 Top Rail Bottom Rail Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 4A FIG. 4B) Lower sash
  • Frigidaire FGRC1244T1 | Installation Instructions - Page 3
    How to Install Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. INSIDE FIG. 6A OUTSIDE
  • Frigidaire FGRC1244T1 | Installation Instructions - Page 4
    Installation Measure the width of the inner side curtain with the provided ruler smoothly, trim the insulation panel then try again, until the insulation panel fits the frame, as shown (FIG.12). Repeat these instructions for the other side. FIG. 10 1 2 3 4 5 6 1 2 3 4 5 6 7 8 9 10
  • Frigidaire FGRC1244T1 | Installation Instructions - Page 5
    in Fig. 16. Vinyl-Clad Window FIG. 16 Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. Remove sash seal from between windows, and unscrew sash lock. Remove screws installed through frame and framelock. Remove the insulation panel and close (slide
  • Frigidaire FGRC1244T1 | Installation Instructions - Page 6
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
READ BEFORE INSTALLING UNIT
Compact Window Mounting (10,000~12,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is
the best way to store unit during winter, or when not
in use.
WHERE APPLICABLE, THE TOP RAIL MUST BE
SECURELY FASTENED WITH ALL FOUR (4)
SCREWS FOR SAFETY REASONS.
A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
D. Secure the top rail to the unit with the 3/8
Ǝ
Screws as shown in Fig. C
Top Rail Hardware
Qty.
4
1
3/8
Ǝ
Screw
Top Rail
The top rail on your unit may already be installed. If not,
follow the steps below.
Packaging
Fig. A
The unit is for window mounting only.
INSTALLATION WARNINGS AND CAUTION
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
s)
2
(
or Wooden windows)
weather stripping
insulation panel
ruler
(10”X3/4”X1/12”)
5
window sash seal foam
1
2
1
16120300A
11362
Top Rail