Frigidaire FMV152KS Installation Instructions (All Languages) - Page 14

Installation Instructions A3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST 5 Secure blower unit to microwave with the screw removed in Step 1. Make sure the screw is tight. 6 Replace blower plate with the screw removed in Step 1. Make sure the screw is tight. Back of Microwave 7 Attach the exhaust adaptor to the top of the blower plate by sliding it into the guides of the blower plate. Adaptor Guide Back of Microwave Locking Tab Push in securely until it is in the locking tabs. Take care to assure that the damper hinge is installed so that the damper swings freely. A4. CHECK FOR PROPER DAMPER OPERATION Blower Plate Exhaust Adaptor Damper Back of Microwave • Make sure tape securing damper is removed and damper pivots easily before mounting microwave. • You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed. A5. MOUNT THE MICROWAVE OVEN FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 14