Frigidaire FPBC2278UF Complete Owners Guide - Page 42

Concern, Potential Cause, Common Solution, Opening/Closing Of Doors/Drawers, Running of Refrigerator

Page 42 highlights

BEFORE YOU CALL Concern Potential Cause Common Solution Opening/Closing Of Doors/Drawers Door(s) will not close. • Door was closed too hard, • Close both doors gently. causing other door to open slightly. • Refrigerator is not level. It rocks on the floor when moved slightly. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. • Refrigerator is touching a wall or cabinet. • Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. Drawers are difficult to move. • Food is touching shelf on top of drawer. • Track that drawers slide on is dirty. • Remove top layer of items in drawer. • Ensure drawer is properly installed on track. Running of Refrigerator Compressor • Freezer control is set to does not run. "OF". • Clean drawer, rollers, and track. See Care & Cleaning. • Set freezer control. • Refrigerator is in defrost cycle. • This is normal for a fully automatic defrost refrigerator. The defrost cycle occurs periodically, lasting about 30 minutes. • Plug at electrical outlet is disconnected. • Ensure plug is tightly pushed into outlet. • House fuse blown or tripped circuit breaker. • Check/replace fuse with a 15 amp timedelay fuse. Reset circuit breaker. • Power outage. • Check house lights. Call local electric company. Refrigerator • Your variable speed • seems to run compressor is designed too much or to run 100% of the time too long. except during the defrost cycle. At times it will run faster, such as after a defrost cycle. Digital Temperature Setting Display Digital temperature displays an error. • Electronic control system • has detected a performance problem. It is normal for the compressor to run continuously except during defrost mode. Call your Electrolux service representative, who can interpret any messages or number codes flashing on the digital displays. 42

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

42
BEFORE YOU CALL
Concern
Potential Cause
Common Solution
Opening/Closing Of Doors/Drawers
Door(s) will
not close.
Door was closed too hard,
causing other door to open
slightly.
Refrigerator is not level.
It rocks on the floor when
moved slightly.
Refrigerator is touching a
wall or cabinet.
Close both doors gently.
Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
Ensure floor is level and solid, and can
adequately support the refrigerator.
Contact a carpenter to correct a sagging
or sloping floor.
Drawers are
difficult to
move.
Food is touching shelf on
top of drawer.
Track that drawers slide on
is dirty.
Remove top layer of items in drawer.
Ensure drawer is properly installed on
track.
Clean drawer, rollers, and track. See
Care & Cleaning.
Running of Refrigerator
Compressor
does not run.
Freezer control is set to
“OF”.
Refrigerator is in defrost
cycle.
Plug at electrical outlet is
disconnected.
House fuse blown or
tripped circuit breaker.
Power outage.
Set freezer control.
This is normal for a fully automatic
defrost refrigerator. The defrost cycle
occurs periodically, lasting about 30
minutes.
Ensure plug is tightly pushed into outlet.
Check/replace fuse with a 15 amp time-
delay fuse. Reset circuit breaker.
Check house lights. Call local electric
company.
Refrigerator
seems to run
too much or
too long.
Your variable speed
compressor is designed
to run 100% of the time
except during the defrost
cycle. At times it will run
faster, such as after a
defrost cycle.
It is normal for the compressor to run
continuously except during defrost
mode.
Digital Temperature Setting Display
Digital
temperature
displays an
error.
Electronic control system
has detected a performance
problem.
Call your Electrolux service
representative, who can interpret any
messages or number codes flashing on
the digital displays.