Frigidaire FPIC3677RF Product Specifications Sheet - Page 3

Built-In Cooktop FPIC3677RF 36" Induction 13" max. C cabinet depth 30"min. for unprotected K cabinet 24" min. for protected cabinet 18" A B min. 4"x 8" opening to route armored cable if base is present ( G ) min. between rear edge of cutout F * and nearest combustible surface (or backsplash) above countertop * Includes clearance needed beneath cooktop to allow for armored cable and installation of junction box on back wall I 25" min. 24" Plywood base ( I ) min. (optional) from right E D edge of cooktop to nearest H ( J ) min. from combustible wall edge of cutout to front edge of countertop ( H ) min. from left edge of cooktop to nearest combustible wall A - Width 36" D - Width (min. - max.) 33-7/8" - 34" Product Dimensions B - Depth 20-1/8" Product Cutout Dimensions E - Depth (min. - max.) 19-1/8" - 19-1/4" C - Height 2-7/8" F - Height (min.)* 3-5/8" Required Clearances G (min.) H (min.) I (min.) J (min.) 2" 2" 2" 2-1/2" K - Cabinet Opening Width (min.) Utility Connection Locations Power Supply 36" Right Rear Built-In Cooktop Specifications • Product Shipping Weight (approx.) - 53 Lbs. • Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. • Connected Load (kW Rating) @ 240 / 208 Volts = 12.0 / 10.4 kW • Amps @ 240 / 208 Volts = 50 / 50 Amps • Recommended Circuit Breaker - 40 Amps • Always consult local and national electric codes. • Cooktop cutout height includes clearance needed beneath cooktop to allow for armored cable and installation of junction box on back wall. Position center of junction box 10" inward from right side of cooktop cutout, and 12" down from underside of countertop. • Overhead cabinetry should not exceed a 13" maximum depth. • Absolute minimum horizontal distance between overhead cabinets installed to either side of appliance must be no less than 36". • Allow 30" minimum clearance between top of cooktop platform and bottom of unprotected wood or metal overhead cabinet; or 24" minimum clearance when bottom of wood or metal overhead cabinet is protected by not less than 1/8" flame-retardant millboard covered with not less than No. 28 MGS sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. • Allow 2" minimum clearance between rear edge of cutout and nearest combustible surface (or backsplash) above countertop. • Allow 2" minimum required clearance from left edge of cooktop to nearest combustible wall and 2" minimum from right edge of cooktop to nearest combustible wall. • Installation of drawer not recommended beneath cooktop. • To reduce risk of fire when using overhead cabinetry, install range hood that projects horizontally a recommended minimum of 5" beyond bottom of cabinets. • Electric Built-In Cooktop model FPIC3677R is approved to be used over any Frigidaire® Electric Single Wall Oven. (Refer to Electric Cooktop Installation Over 30" / 27" Electric Single Wall Oven Specifications page on web.) Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Granite Countertop Installation Kit - (PN # 903061-9010). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FPIC3677R 01/16 © 2016 Electrolux Home Products, Inc. Accessories information available on the web at frigidaire.com Specifications subject to change.