Frigidaire FPID2498SF Complete Owner s Guide - Page 19
Removing Spots and Film
View all Frigidaire FPID2498SF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
BEFORE YOU CALL Etching • Using too much detergent especially in soft or softened water causes damage that looks like a film but cannot be removed. • Adjust the amount of detergent based on the water hardness. (Check Detergent Chart). • Lower the water temperature. Stains on Tub Interior • Washing large amounts of dishware with tomato based soil can cause a pink/orange appearance. This will not affect performance and will gradually fade over time. Pre-rinsing or using the Rinse Only cycle will reduce the chance of staining. Using air dry option will lessen staining. Dishwasher has an Odor • Soiled dishes left in dishwasher too long can create an odor. Use Rinse Only cycle. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly. (See Dishwasher Does Not Drain Properly). Vapor at Vent Dishwasher Does Not Drain Properly • If unit is hooked up to a food waste disposer, make sure the disposer is empty. • Check to see if the knockout plug has been removed from inside the food waste disposer inlet. • Check to see if drain hose is kinked. • Make sure cycle is complete, not in a pause. • Spilled rinse aid can cause foam and lead to overflowing. Wipe up any spills with a damp cloth. • Check to see that dishwasher is level. (See Installation Instructions). Dishwasher Won't Run Opening the door during cycle • If the dishwasher door is opened while the unit is running, the START/CANCEL pad must be pressed and the door shut immediately to return the unit to the selected cycle and option. • Check to see if circuit breaker is tripped or if a fuse is blown. Removing Spots and Film • Make sure water supply is turned on. Hard water can cause lime deposit buildup on the • Check to see if cycle is set correctly. (See interior of the dishwasher. Dishes and glasses Operating Instructions). may also get spots and film for a number of • Is dishwasher set for Delay Start Option? reasons. (See Glassware/Flatware Spotted or • Make sure door is closed and latched. Cloudy section). To remove buildup, and film, Glassware/Flatware Spotted or Cloudy clean using the following instructions: 1. Load clean dishes and glasses in normal • Check water hardness. For extremely hard manner. Do not load any metal utensils or water, it may be necessary to install a water silverware. softener. (See Detergent Chart). 2. Do not add detergent. • Water temperature may be low. Avoid 3. Select the NORMAL cycle. Press START/ extremely low or high temperatures. (See CANCEL pad. Close and latch the door. • • Factors Affecting Performance. Avoid overloading and improper loading. (See 4. Preparing and Loading Dishes). Use fresh detergent. Old detergent is 5. Allow dishwasher to run until it starts the second water fill (approximately 10 minutes). Unlatch an and open door and pour 2 cups of ineffective. white vinegar into the bottom of dishwasher. • Make sure rinse aid dispenser is filled. 6. Close and latch door and allow cycle to finish. • Check to see that proper amount of detergent is being used for cycle selected. Also, check phosphate level. (See Detergent Dispenser.) • Home water pressure may be too low - it should be 20 to 120 pounds per square inch (psi). Dishwasher Won't Fill • Is water supply turned on? 19