Frigidaire FPRU19F8QF Product Specifications Sheet - Page 3

All Refrigerator FPRU19F8QF 18.6 Cu. Ft. Recessed electrical outlet 25 1/4" min. side panels, 24" 1/2" min. width 25" 26 1/2" 32" Cabinet (Trim Kit installation requires Countertop 3/4" min. width) (Single Trim Kit shown.) A C B Reversible Kickplate Top Trim Piece (for 75" opening) Louvered Grille (for 79" opening) Trim Kit D Cut off 4" for 75" opening 4" E 71 3/8" Optional Trim Kits & Dimensions Kits include top and side trim pieces, louvered grille, reversible kickplate and leveling system to fit 75" or 79" opening height. Single Louvered Trim Kit PN # TRIMKITEZ1 (D) 75 1/8" or 79 1/8" (E) 34 3/4" Double Louvered Trim Kit PN # TRIMKITEZ2 (Includes hardware to secure side-by-side units together.) (D) 75 1/8" or 79 1/8" (E) 67 1/8" Note: Both kits attach directly to cabinetry through top trim piece or louvered grille to stabilize unit(s). Refer to detailed kit installation instructions packed with kit or on web. Allow at least 571/4" with door in 90° open position 70 5/8" Power cord location (right bottom rear) 24 1/4" 29" to handle extension AllRefrigerator Cutout Dimensions Built-In Installation (without Trim Kit) Single Unit (A) 72" (B) 33" (C) 25 1/4" min.* Double Unit (Side-by-Side) (A) 72" (B) 66" (C) 25 1/4" min.* Built-In Installation (with Trim Kit & Leveling System) Single Unit (A) 75" or 79" (B) 33" (C) 25 1/4" min.* Double Unit (Side-by-Side) (A) 75" or 79" (B) 66" (C) 25 1/4" min.* Leveling System (2) per unit raises height 2-9/16" min. Only available with trim kits. *Minimum depth from face of cabinet side panels and requires recessed electrical outlet. Built-In All-Refrigerator Specifications • Product Shipping Weight - 240 Lbs. • An electrical supply with grounded three-prong receptacle is required. The power supply circuit must be installed in accordance with current edition of National Electrical Code (NFPA 70) and local codes & ordinances. • Voltage Rating - 115V / 60 Hz / 20 Amps • Connected Load (kW Rating) @ 115 Volts = 0.55 kW • Amps @ 115 Volts = 5 Amps • Always consult local and national electric codes. • Minimum 25-1/4" depth requires recessed electrical outlet. • To allow for ease of installation, tape excess power cord to back of unit. • When installing refrigerator adjacent to wall, cabinet or other appliance that extends beyond front edge of unit, 20" minimum clearance recommended to allow for optimum 140° door swing, providing complete drawer / crisper access and removal. (Absolute 4" minimum clearance will ONLY allow for 90° door swing which will provide limited drawer / crisper access with restricted removal.) • Refrigerator must be placed on level surface of hard material, same height as flooring. Surface must support approximately 800 lbs. when fully loaded. Unit equipped with 4-point leveling. "Built-In Look" Specifications • Minimum opening of 72" H x 33" W x 25-1/4" D required for singleunit "Built-In Look" installation; 66" W required for double-unit installation. (72" H to be measured from finished floor to underside of soffit or overhead cabinet.) • Remove all wall / floor molding prior to built-in installation. Optional Trim Kit Specifications • If optional Single or Double Louvered Trim Kit is to be used, different cutout dimensions are required. Kit can be adapted to fit either 75" or 79" opening height. (Refer to cutout dimensions on this page and detailed Louvered Trim Kit installation instructions included with kit or on web.) • Remove all wall / floor molding prior to built-in installation. Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions. Optional Accessories • Single Louvered Trim Kit - (PN # TRIMKITEZ1). • Double Louvered Trim Kit - (PN # TRIMKITEZ2). • PureAdvantage® Air Filter Replacement Cartridge - (PN # 241754001). USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca FPRU19F8Q 09/14 © 2014 Electrolux Home Products, Inc. Specifications subject to change.