Frigidaire FPRU19F8RF Complete Owner's Guide - Page 12
Interior Lighting
View all Frigidaire FPRU19F8RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INTERIOR LIGHTING Mid-Level Lighting (some models) The mid level and upper level lighting comes on automatically when the door is opened. IMPORTANT To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage. To replace the light bulbs: 1. To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord. LED Light Removal 2. Remove the lens from the lamp housing by unsnapping it from the lamp housing using your fingers or a screwdriver. Be careful not to break the locking tabs on the lamp housing. 3. Replace the old bulb with a bulb of the same type and wattage. 4. To replace the lens, snap one side of the lens opening to the tab on the lamp housing. Then carefully attach the other side. LED Light Harness Removal NOTE LED lights are in series, so if one is bad or unplugged, several lights may not light up. To Remove Light Lens Press Tabs in Direction Shown Upper-Level Lighting (some models) The upper level lighting comes on automatically when the door is opened. Mid Level Lighting IMPORTANT To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage. Mid-Level Lighting Light Bulb Removal LED Lighting (some models) To Replace LED Lights: 1. Unplug the power cord. To replace the light bulbs: 1. To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord. 2. Remove light cover by pushing up and out. 3. Hold the LED cover with one hand and pull the connector with the other hand while pressing the connector latch. 4. Replace LED light and snap in place assuring the light is facing in toward the unit (inside fresh food). 2. Remove the light shield by pushing in on the sides where the two tabs are located in the back, then rotate the light shield down and out. 3. Replace the old bulb with a bulb of the same type and wattage. 12