Frigidaire FPRU19F8RF Wiring Diagram
Frigidaire FPRU19F8RF Manual
 |
View all Frigidaire FPRU19F8RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Frigidaire FPRU19F8RF manual content summary:
- Frigidaire FPRU19F8RF | Wiring Diagram - Page 1
20% 20 to 30% Refrigerator Temperature 35° to 40° F 2° to 4° C 35° to 40° F 2° to 4° C Low Side Pressure (cut-in) servicing. important If any green grounding wires are moved during servicing, they must be returned to their original position and properly secured. caution: All electrical parts
-
1
 |
 |
PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT MID-POINT
CONTROL SETTING
Capacitor Run or
Induction Run
70°F (21°C) Ambient
90°F (32°C) Ambient
Operating Time
10 to 20%
20 to 30%
Refrigerator Temperature
35° to 40° F
2° to 4° C
35° to 40° F
2° to 4° C
Low Side Pressure
(cut-in)
25 to 30 psig
175 to 205 kPa
25 to 30 psig
175 to 205 kPa
Low Side Pressure
(cut-out)
10 to 15 psig
70 to 100 kPa
10 to 15 psig
70 to 100 kPa
High Side Pressure
(last 1/3 cycle)
120 to 130 psig
810 to 880 kPa
175 to 185 psig
1180 to 1260 kPa
Wattage (last 1/3 cycle)
120 to 180
140 to 155
Amps (running)
.8 to 1.3
1.0 to 1.5
Base Voltage
115 vac (127 vac max)
DEFROST SPECIFICATIONS
Cabinet Size
Thermostat
Heater
Cut-in
Cut-out
Watts
Ohms
19’
37° F (3° C)
47° F (8° C)
550
24
Electronic Timer - Defrost 30 minutes every 12 hours of compressor run time.
CONDENSER FAN MOTOR
Watts
RPM
Amps
2.3
1100 CW Opposite Shaft
0.13 Running
IMPORTANT: PLEASE RETURN THIS SHEET TO IT’S ORIGI-
NAL LOCATION
SERVICE DATA SHEET
-
297299900
STANDARD - AUTOMATIC DEFROST
REFRIGERATOR MODELS (
R134a)
IMPORTANT SAFETY NOTICE
The information provided herein is designed to assist qualified repair
personnel only. Untrained persons should not attempt to make repairs
due to the possibility of electrical shock. Disconnect power cord before
servicing.
IMPORTANT
If any green grounding wires are moved during servicing, they must
be returned to their original position and properly secured.
CAUTION:
All electrical parts and wiring must be shielded
from torch flame. Do not allow torch to contact insulation; it
will char at 200°F.
NOTE:
Products come equipped with an Electronic Defrost Control.
To initiate defrost, press and hold air filter and alarm reset key
simultainiously for three seconds.
To terminate defrost, press and
hold air filter and alarm reset key simultainiously for three seconds